Search results

Hi Just about to lay a 50sqm patio I know I should use sharp sand but I've got about half a bag of builders sand left over from a build Could I mix this in with sharp but only a small ratio to use it up or best not too Would use sharp but need to get rid of the building sand somehow and...

Need a slurry as porcelain won't absorb much from just a mortar bed and won't bond

Where is the drain currently? Also not sure what image 3 refers to as can't see that on image 1. If the drain is where the downpipe near the stonework is the long downpipe could have come down the join in render rather than being at the other side

does the path run away from from house or does water sit there

Are you sure he's finished? Your battens are going to rot and you're relying on the membrane to keep the water out which won't last long

Could you just remove it and adjust the falls to the left one? Could possibly be too much water depending on roof size

Could be the below by the looks of the potato shot. Search for blum cabinet mounting plates

Check that the tiles are all exactly the same size and it's definitely the alignment rather than size

Yes, porcelain can laid on top of concrete with outdoor tile adhesive no problem

I've had similar. I used a sucker to attach to the tile and then was able to pull forwards Don't think yours are smooth enough to do that but could try and insert a tent peg/hook through the gap and twist/pull Mine were hold on with a few small blobs of silicone

As above, balcony window but they then swapped to a standard one for some reason. Are there views from the window?

If you look at the lip of the shower tray as you walk in and then the lip at the back near the plug that will show the inbuilt fall. If you have a longer level you will see how far out the outer edge is but as said above if it was miles off the screen wouldn't fit and hopefully you'll just get...

I'm guessing a cm. At least it's going the correct way, almost as if they installed it with a fall instead of flat

Does the concrete fall away from the house currently? If the concrete is in good condition you can lay 10mm porcelain with external tile adhesive so total height approx 15mm-20mm

Can't you use the manufactured edge at the front and cut the back? Or if just using normal mdf the sheds will cut strips for you

I'd be concerned what blocks the beam is sitting on too.

I've just completed the shell of a 7x4m extension and total cost so far is 11k Thats everything to get it watertight before the insulation / electrics go in I've done everything myself though.

Does it need to look exactly the same? https://www.ebay.co.uk/itm/175586326937?itmmeta=01HXWC31ZFKJ8XEEZS5GKC13YA Available with the switch text you need

From your level on the outside lip it's probably about an extra centimeter off level across the length which exaggerates it

The tray should be level around the outside lip. There is a built in slope towards the drain internally but shouldn't be that noticeable. Install looks fine