Search results

I'd like to install a new external alarm box for my TS900 and I've purchased the Honeywell AG6. I'm installing a new external sounder (Honeywell AG6) to menvier TS900, I think the connections should be as follows, can somebody confirm:- TS900 AG6 ==== ====...

its a TS900, when I add the xnode the remote keypad seems to sense its there but the zones don't work. There are the network connections there for the xnode so I assumes it supported it also given the alarm can see its there via the remote it would imply its picking it up I thought.

Hi there, Not being an alarm engineer I guess since I don't see those zones and the removal of the loop wires from the remotes don't trigger the alarm they must not have been enabled. I also guess that the engineers code is required so as to get into this side of the config which now is no...

I have two remote keypads each of which appear to have two zones within the remote keypad but these do not show up within the zone list. Do I have to enable these in any way and if so how is this done? Many thanks...

Hi All, Well the fan on the 260 failed again having shutdown the CH system. I found that when I placed a meter across the power feed to the fan i got 240V but the fan was not turning. The bearings were fine so I knew the problem had to be something else. This time I started to remove the...

OK, so here's the problem I have. I have a power shower pump installed (Watermill) which is used to deliver hot/cold to a mixer shower enclosure. The shower enclosure while we don't use them have 6 water jets, monsoon shower head, normal shower head which we do use all of which is controlled...

Hello, I'm just starting to plan the re-install of my powershower due to having to replace the last coupe of pumps over a three year period:( I'm told a need to install an essex flange and that this will need to feed the hot supply to the pump. I saw your aticle and thought yep that the...

Hi there, I had the same issue as you with a Mira mixer shower and when i pulled it apart I had the same parts as those you have put pictures up of. I found that limescale had blocked the flow of water and having bought a new insert and installed it the presure was then fine. The insert cost...

Ok so if I understand you correctly I have to be at the output side of the pump for the flow to work:( Problem with this is that there's no local rads from which I can take the feed from. I was going to use a lockshield valve on the return side to balance it but guess this an't going to help me...

Hello there, I had the very same issue and it was indeed the flu fan that was causing the issue. They are about £108.00 to buy new so what I found was the noise was being caused due to the bearing being seized on the motor. I simply removed the two cross blade screws and removed the upper part...

Hi there, I have enough BTU left in the scope of my boiler and want to add a rad into the same room as the boiler is located in. What I need to know this, is there a min distance from the boiler 22mm pipes flow and return from which you can take the first radiator feed from? Including the...