Search results

Just got around to thinking about this. Not sure if you can understand my sketch or not as it is a bit like spaghetti junction. Like a lot of heating system wiring done in a single back box.

Thanks for the reply. Appreciate the advice. So I can take the pump supply from ufh manifold to the LNE in my wiring centre, send a live from the pump in my wiring centre to the ufh wiring centre and then use the a supply from boiler 2 in ufh wiring centre to switch live on valve (brown wire)...

Ahh gutted. Thought I would get one reply. Stem usually answers my questions but no such luck. Could anyone point me in the correct direction? I was typed into Google the issue I have and a thread came up on this site with someone who was asking the same questions as me. I accidentally closed...

Hi all. I hope you are well. I have just installed a underfloor heating manifold with the above controls.mplease see image attached. This is attached to a combi where I have installed 2 zone valves so basically an S plan. Now looking at the wiring centre schematic, it does not go from the usual...

Thank you so much for the informative reply. And for giving me the low down on the forum rules. I shall remember this for next time. It is as you say, boiler and programmer downstairs, wiring centre in airing cupboard and stat in the hall downstairs. Hopefully I can disconnect the programmer...

Hi. I know this thread is old but need a bit of advise on where you remove and link the wires from the room stat. On an Honeywell S plan, do you remove terminal 4 and terminal 5 and then link the terminals together? So the stat wires are useless? This way you cannot use the old stat wires for t1...