Search results

The hot water would not switch on ( No led light either ) and the lcd display panel lights were flashing on and off.The heating was on at this time. I switched the heating off and it would not switch back on. You could hear a faint attempt from the relay at switching on. Is the...

Thanks for the post, I'll pass the info on.. October.

My friend gets the error code E9 on his display and the hot water goes cold. He was advised to check the pressure and its sitting at 1.5bar. The fault is intermittent. Any help would be most appreciated, thanks... October.

My friend has the error code E9 on his display and the hot water goes cold. He was advised to check the pressure and its sitting at 1.5bar. The fault is intermittent. Any help would be most appreciated, thanks... October.

Got up this morning to a half full ice box .....yeehaaa. Thanks for your help Leccy.

Thanks Leccy. Model is not on that website, too old I guess. Looked at the user manuals they had anyway & at least managed to cancel the filter change light. Hopefully it's a time duration thing it's got to go through and I'll get up in the morning to a half full ice box. Thanks again...October.

I've just bought a used fridge freezer that had never been plumbed in for ice or water. I can get water at the dispenser but the ice tray won't fill up. Didn't get a user manual so any help would be most appreciated. Thanks......

Ended up getting a heating engineer in today. Gave him the story so far, & he started checking things then eventually said he was stumped & reckoned the new diverter valve must be goosed. He fitted another new one & fingers crossed it's been ok now for 3hrs. Many thanks for your help weargas...

Yes. The tube was fine.Took it out,blew it through ok and checked ports on either side.

Diverter valve arrived on 24th Dec. Fitted it and the heating started working. Woke up on 25th and it was back to the original problem. Went to Tenerife on 26th and just back today so i've beeen warm for a week at least. I've not tried to clean out the filter mentioned on an earlier post as...

Thanks for the information folks. I've ordered a diverter valve so it's big jumpers and jackets time till it arrives. I'll let you know how it goes......

Thanks for the information. Tested ok for voltage at both test points. Any ideas as to what resistance should be through the divereter coil? This one reads 2 Meg Ohms which seems to me awfully high. There is a magnetic pull at the coil though. Thanks....

I have a Worcester Bosch Highflow 400. The pump seems to be working ok. I removed the head and the impellor is still attached and spinning freely. Both the inlet and the outlet from the pump heat up. I removed the diverter valve and part stripped it. There was a few bits of dirt in it but not...