Search results

Hi I've basically ripped everything out now as the floor was sodden and rotting. See below for pics. I want to change the soil pipe. The white soil pipe fits in the grey one through a rubber seal - the leak appeared to be coming from here. I took the white soil pipe out but when I tried to put...

Lino floor tiles with plywood underneath.

The sodden floor is now just damp. It is still drying but it looks like it might take weeks to properly dry. If I can get it to dry, is it wise to reuse it or would it be best to replace it? The floor has warped a little.

Thanks for your help. I bought a flexi connector and tried your suggestion but still couldn't find a leak although the flexi itself did leak a bit but I guess that is because I had it bent 90 Deg. Anyway, the leak must be coming from somewhere else, which is going to be a pain to find because...

I'll give that a go. Any ideas on how to seal it? As a test I was going to try a bin bag and some gaffa tape...

Hi PBD, The toilet is 9 years old. I think I am going to try and hook the cistern up outside and flush it with kitchen roll around the base to see if that reveals anything.

Hello all, I have a top floor flat in a 7 flat building constructed in 2007. Toilet is close coupled. I have had a small water leak in the spare room bathroom for a few weeks. It appeared to be coming from the toilet where you could see a slight bubble of water coming from between the lino...

Hi, Just as a follow up to this; the mechanics have performed a dial test and told me the front non-drivers side hub is out of alignment (value of 10-15 was quoted) and that the bearings on the drivers side are going (again) although the dial test didn’t show an issue on the drivers side. Is...

Thanks John! I'll find out if this has been done previously when I've taken it in (it has not been mentioned). Would an issue require a change of the hub assembly?

Hi all, Car: Peugeot 207 2008 1.4 petrol 60k miles A few months ago my front right tyre partially deflated after hitting a pot hole (I think) then a minute or two later as I was turning left the car span and the front right wheel hit the curb sideways at perhaps 15 mph and mounted the...

Hi, My idl 40 s dishwasher has stopped working - it will not turn on and no lights show when I press the power button. There was was in the bottom so I have drain and cleaned the filter. Any ideas? Would anyone recommend calling out indesit or just go straight for a new one?

Ok thanks. Can anyone replace a thermostat or can only a qualified electrician do it?

Hi all, I have a Santon Premier Plus Imersion heater in a stanadard unvented system and have an issue... My immersion heater comes on for a couple of hours in the early morning to provide us with hot waterfor the day. This has been working fine for years but recently I have found that the...