Search results

yh but you can still get that setup going i would agree if it was the whole house. but the 35cdi want have a problen and if you try isoling each other rad on the trv it will tell you if you can get the rad going without a re pipe and after sometime they should more orless be the same temp

all i would do id lay the 32mm along the slop og the roof into the guttering but the down pipe has to go to a drain not a soakaway unless there is lime chipping and 600mm away from the building

a home buyer report is mayby and might be asbestos is every ware as long as you do not desterb it you are ok and if you do the cement based id not that bad (well it is but instead of getting hit by train you getting hit by a car it all kills) if you have to remove it just take it as and use...

hello there is nothing wrong with that layout as someone else has said it is just a 1pipe system it will just take a while to heat all 3 rad but a 35cdi will do it in no time i would not waste your money you don't need to adjust the top of the rads it is just air and balancing try turning...

so you only have the 1 master and the rest should be slave

i might look at the logic, they are supost to be getting better. my vaillant is 3 yrs ond i had a intermitant fault the pcb was shot and the was gonna replace the ntc, you notice it when it is ur own boiler (i'm 23 and paying a morgage as many are) the rubber hose had a worp in it aswel...

hello i have move into a 2 bed house that had a telephone socket in the following rooms (downstairs) lounge/ dinner 2, kitchen1, hall way1, utility1, entrance1 (upstairs) landing1 , bed1, bed1, cloakroom1, loft 1 the first is the loft and then goes other places from there the phone...

I like the vaillant and glowworm don't mind the baxi as a cheeper option worcester has gone down hill also where is the best place in birmingham to get boilers or the internet

it don't matter i no most will charge you the same as it is there name on the cert i no i would and if there are any leaks i would advice first it would be your responsibility (could fix at aditional price) sound mean but its not worth there time to go out (i no i would not let...

alright m8 check these fo me hold hown P for ten seconds until the display show a spanner set the eco to 5.0 with the twisty knob fully anti clockwise then presss the knob in and set the dhw set to 60 press p again to get out of that mode go to the boiler and with the hot water control...

yes the 360is good but just compecated for the customer i have not worked on 1 for over a yr as i had loads of call backs, tou have a base tempreture for the house and a eco setting on the hot water where is the boiler fitted

don't 4get to put at least 1m of copper from the boiler, i like speedfit due to the colour but textit is the best just the cost always stick with copper tho, old school

you should not worry they are all tested the same, you can get a leak ether way but 0.1per cent out of a 100. don't worry

the floor screed can be any depth depending on your builder and if u dig close to the wall you will find it the best, the gas is supost to be approx 25mm below floor level but possibly isn't my company want allow pressurized systems if there is any pipework in the floor but on the side i just...

what it is if the frost protection in the boiler or external, even the 360f has a frost protection in the vaillant it is set to fire up below 5*c hope it helps (DID U WANT THE 360F)

what it is if the frost protection in the boiler or external, even the 360f has a frost protection in the vaillant it is set to fire up below 5*c hope it helps