Search results

Yes, that's a possibility.

Are keypad diags showing 100% in menu 61.1.2 ? It sounds like bus traffic corruption, but not enough to cause the keypad to drop and cause a tamper. Either that or the keypad has an issue and will need replacing. Do you have a speaker connected to the panel and did it sound?

The alarm should be detecting the zone state. Be careful with wireless, as the zone will not keep opening and closing with every movement. To conserve battery power, the PIR will back off and only report again after a quiet period. So if you're testing, close the tamper, then get someone to...

As the G2 panel doesn't support SIA, you will need to decode the RF portal transmissions. If your portal is set to address 5, set the vmod virtual RF portal for address 5 to 'read only' mode. You then need to decode the pportal mqtt topics. There's an example of the yaml code for this in the...

You don't have messaging enabled for a PM. You'll need to PM me.

Hi, I'll PM you.

It's normal. The sounder requires 12v for hold off, or it will power the siren from battery for ~15 mins.

Engineer 51.21 can reset the manager code.

There are some options to switch to IP by adding low cost IP module to your panel. I'll PM you details.

Yes, as long as your panel supports additional RIOs you can add to gain more outputs. When you have an RF portal fitted it will enable virtual RIOs to give additional zones, but you can disable those and add physical RIOs in the address slots instead and then gain the outputs.

What are you looking to do, as there may be other options.

Is the prt entry zone on the route to the keypad? It acts as an exit zone in day mode, and it looks like the panel is logging it's activation as part of the entry route which is normal. Your log above doesn't look complete, as there should be a + and - showing the zone activation and...

The portals are input only.

Are you receiving the push, but also getting the com4 error or, nothing. If you have RSS can you send me a copy of your site and I'll check to see what's wrong. Also, which panel type is it?

For the Honeywell reporting, you need to set the protocol as SIA and the port that they tell you. If you use SelfMon reporting, the protocol should be set to Microtech. Some of the older Ethernet modules are problematic and give com errors. The latest module V4.16 doesn't suffer from these...

You can always fit or get someone to fit an IP based module to send events to your phone. Or you could have reporting disabled and have a bells-only system.

How many receivers have you configured ? They will be listed in menu 56 Comms -> Receivers. Check the 4th receiver to see what you've set as. It's easier to program and check programming if you have Honeywell RSS.

Hi, you need to install the app, then click on further instructions.

Have you restarted since removing all zone and user references to those groups? Major config changes on the galaxy may require a 51.17 restart.

You can upgrade with either SPI key or RS232 lead. You can store the config to the key and restore after upgrade, as the upgrade defaults the settings. If you're on selfmon, pm me and I'll lend you a key to upgrade.