Search results

yes the soil is vented above the gutter level and isnt blocked.

Not possible now , but I dont think that would help I think it happens when either the bath is emptied or the toilet upstairs is flushed as the shower is boss is at ground level and everything else is above it .

Went to a guys house whose shower smells every week or so. The shower never gets used and loses its water seal . The shower is on the ground floor on a 40mm waste pipe with a basin teed into it then it goes straight into the soil pipe , distance from shower to soil pipe is 2m. The soil...

The wireless room stat may need retraining , here are the instructions on how to set it up http://www.eliwell.it/NR/rdonlyres/BCB8B672-C982-4A21-A4AB-4E4411591559/0/DigistatRF3Instr.pdf

Check for voltage at the solenoids .

motorised valve or programmer or room stat , most likely is the motorised valve

And you want advice on what exactly??????????????

it will be the auto air valve needs replacing , this is on your central heating not on the cold water or domestic hot water side hence why it didnt stop when you turned off the mains , it will be draining the central heating . Easy enough job for any competent engineer .Price of auto air valve...

this is a heat only boiler , so check if the pump works , has the system got water in it , have all the bleed valves been bled to check for air ?????

sounds like a faulty pressure relieve device

seperate the feeds to the pump and the boiler , and connect just the pump up to mains and let it run without any power to the boiler and see if the fuds if it does then your pump has had it , if not the fault is on the boiler blows , but you need to workk out exactly where each wire goes , or...

Mouse has gone wonky ie it wont go where you want it to , a usb mouse works fine , does this mean the touchpad mouse has gone faulty ??? is there anything I can do about it??????

As has been said you have two option , either dig up the floor and move the drain or batton out the wall between the cistern

thanks for that link but they only list spares for new models , this must be an old discontinued one so they dont list it :evil:

Any one know where I can get spares for this item the inernal fuse has blown , not sure if the element has gone it is giving a resistance reading of 91 ohms , not sure if that is good or bad , any help appreciated

if you cant undo it , buy new taps!!!!!

need more info on your system , could be a motorised valve sticking on . but unless we know what you have its hard to diagnose it.

three way valve usually by the cylinder is faulty , probably the motor inside has gone . as a temp solution there is usually a manual lever on it which will get the heating working untill you can swap it

It depends if it has an integrated filling loop or a silver braided hose under the boiler see page 35/36 on this valiant . http://www.vaillant.co.uk/stepone2/data/downloads/f8/42/00/ecoTEC_plus_937_installation_manual.pdf

you need to get the pressure guage up to between 1 bar and 1.5 bar and bleed all the rads to get any air out . then see if you get any error messages