Search results

As the subject says; fitting one of these locks and drilling the hole in the door for the locking bold to fit into is a problem. I was expecting the sliding door frame to just be extruded UPVC and hence easy to drill the hole to take the locking bolt. After drilling through the outer skin...

Preecy, I have been thinking about the same problem I have with bath already installed against a corner wall for a few years now. Was also thinking of changing bath as mine also has raised lips at either end. So Bingo on the pic of the shower screen you have posted. Can you tell me where I can...

What type of system is it ? Fully Pumped or Pumped Central Heating and Gravity Hot Water. I have the Installation manual and they are different. I'll have a look if you tell me, failing that I can spend a little time scanning it and sending to you. n.b. but how many times will people take wires...

Unblock the blockage ?

Yes, but it will cost you £50. Did you call me earlier ! Sorry, can't help, but couldn't resist either. Have you tried the maker ?

The machine manual will tell you if it can handle that.

Sludge !

Sounds like 'no flow' and rad cold at the bottom is a classic sign of blockage, probably by years of sludge. Remove rad, flush out sludge and replace.

Not much to offer given what youve already checked other than to say that lot of appliances these days have their own internal fuses and more than one in many cases.

You do if its controlled by a battery operated device..........and its telling you the battery is low.........and you admit you saw and and couldn't be bothered............

Reminds me why I stopped wasting my time trying to help people here :!:

Are you doing a 'like for like' test ? or are you turning the drum by hand when it is empty hence bearings and other bits not loaded, unlike when the machine is having to turn it with wet, heavy clothes inside........

Just out of curiosity I did one google search - and found the answer......

Probably find what your looking for here. I did almost 10 years ago and still happy; http://www.eastmidlandswater.com/default.asp?menuID=1

Age of machine; how long has this been happening, etc, etc ? Common problem with (older) laptops is that the fans get blocked with dust, have you cleared both fans and vents of dust ?

See my post here http://www.diynot.com/forums/viewtopic.php?p=576500#576500 and a few others. Still delighted and service 1st class.

Sounds like you may have already answered your own question; i.e. a venting problem rather than a blockage in the drain pipe.

They are always the same shape as the tray i.e. in this case curved. If yours is straight, you have the wrong panel.

OK, a relay then. It was about 6 years ago, just trying to give the guy a hand........ EDIT. Now you've jogged my memory, it was a 3 legged can. But the points about the quality of these PCBs and the faults found on them remain.

I think Gasguru has nailed this. I had the same fault on the same boiler, it was the gas valve juddering. Seen many comments over the years on the PCBs in these boilers being iff'y and that was the case with mine. Traced the PCB circuit back from the valve to the switching transistor and it had...