Search results

jondiy I had a query about this one time as well, i would not worry about it, its fine.

Anybody know who deals with clipsal products? Rang, newey & eyre, cef, denmans, nobody does them

lol, I have to back that one up about screwfix forum, picture that scene in apocalypse now were martin sheen is going up the red river delta to assasinate marlon brando, thats how your head will feel if you go to APOCALYPSE SCREWFIX

Anybody ever been to one of these before? Are they any good? http://www.elexshow.info/intro.htm

Baldy, what about lsf?

Spark123 I should have said, yes i did that test on RCD, thanks for reply

Fellas, Still learning my way regarding fault finding, wondering if anybody can see any flaws or would they do it a different way with a slight problem today. Split load board, 3 ring mains and a shower on RCD side, its a clipsall CU and i noted it was a terrible install. RCD...

lol, i got loads pensdown. Its not that i havent got the info, its what and how the question is worded, note it says initial inspection and not initial verification

State the three general requirements to which installed equipment must conform when carrying out an initial inspection? now i got gn3 in front of me and every other book going, it is not apparant that there is "three" of anything? any help please fellas

RF Lighting In that case there should be no DI registration at all

pensdown i couldnt agree with you more, its getting really out of hand. I am going NICEIC Domestic Installers (just waiting for paperwork now) and i have made my mind up that i am going to do PIRs regardless. My way of thinking is I am supposed to be competent? the people who are...

cozycats form one cat to another thats CLEAR

The NICEIC has a "DOMESTIC INSTALLATION PERIODIC REPORT" Certificate, Can Domestic Installers issue these certificates? I was always under the impression that only approved contractors can issue PIRs?

Thanks Pensdown

Fellas, What is the unit measured by an RCD test machine?

james29, is spot on with everything he has said. If i was your age i would not even dream of going in for installation full time. Do the 2330, then go for a degree, you got time on your side.

found the answer from scaddans book. "When the supply is connected, it is important to check that the incoming supply is correct. This is done using an approved voltage indicator at the intake position or close to it" yeh right

Gents Got a question here asking me how i would test polarity with the system energised, dead test is ohmmeter what answer are they looking for here?

Gents What does Uoc represent in the earth fault loop impedance formula please?

cmon mate your english does not look to bad to me. In other words you want a logbook off someone, you might find someone gullible if your lucky enough