Search results

Hi All I have just replaced the element on my Bosch 1200 classixx but after putting back together I now get a loud knocking and excessive vibration when the machine goes to full speed spin. Looks like something is out of balance but can't see anything obvious, any idea's suggestions please?

Hi I have an mcb which is on my kitchen circuit which is tripping, the installation is about three years old and although I undertook the installation it was was checked and signed off by a local electrical company for building regulations when I built an extension. it has a split load board...

Hi Has anyone got a picture or diagram of how a grp valley falling into an internal 90 degree gutter corner should look when completed correctly. I am getting a leak into my soffit which I am told may be that the valley does not extend far enough into the gutter. Also...

I have a wooden front door and frame. The frame which I had built had a thin plastic strip rebated into the threshold which the back of the bottom of the door closed onto. Can someone tell me what this is actually called and where I can buy one from? The original one was too high and was...

Hi Having a problem with a Texecom LCD RKP which does not appear to be connecting to my alarm panel. I have spoken to and sent a picture of the panels circuit board to Texecom technical support who stated that the RKP should work with my panel (but they are now closed for the weekend!) The...

Hi I want to put in four 50w lights on a twin wire suspended cable system, and have been advised by a lighting supplier that as I wish to use 6.5m spans I will need 2 x 300w Toroidal Transformers. This seems a bit over the top as Ikea sell a set to cover 9m with a single transformer? Can...

Hi I have a Worcester Bosch Camray 25-32 oil fired boiler which has just been fitted, my electrician has wired it up and I ran through the pre comnissioning checks and fired the boiler up and it ran for a few minutes the stopped. The boiler is now not working despite having electricity to the...

I have a wiring diagram for a four zone heating system which shows a SPDT (Relay), this is to control two separate heating zones. One for two underfloor heating systems and the other for two additional heating zones. The controllers are Honeywell ST9500. Has anyone recommendations for...

I have a wiring diagram for a four zone heating system which shows a SPDT (Relay), this is to control two separate heating zones. One for two underfloor heating systems and the other for two additional heating zones. The controllers are Honeywell ST9500. Has anyone recommendations for...

Hi In the process of restoring some old cast iron rads, I have shot blasted them and got most of the old plugs out but a few just won't shift!? They seem to be crumbling rather than coming loose, there is nothing to say they have been machanically fixed as I have drilled one out? I have...

I am currently running cable to a house extention/garage which is being checked by my local council, under a building control notification so it will all be checked just don't want to look a numpty! Can someone give me advice on what size cable to run to a ring main in my garage which is 5m...

I am building an extention and arranged for a local truss manufacturer to come and measure my existing roof for trusses to match the existing. They measured the roof at 7.1 width and 2184 high when I measured the roof it is in fact 7.08 wide and 2150 high, resulting in a significant...