Search results

Thanks for the advice, just a thought, has anyone ever drilled the hole through the tile and plasterboard and if there isn't any dot behind the plasterboard to inject some tile adhesive into the void? wouldn't this help?

I am looking for advice please for fitting a heated towel radiator to my newly fitted bathroom. The rad will be fitted to 30x60 porcelain tiles fixed to plasterboard dot and dab on an external wall thermalite blocks. The radiator is large weighs 19.7kg so I am looking for suggestions for...

Thanks for your replies. So are you saying that the only reason check valves need to be fitted is it is technically possible for the shower head to syphon water back through the system from dirty bath water? would check valves significantly affect pressure to the shower with my hot water...

Would appreciate some guidance please. I am fitting a thermostatic shower bar above a bath (Bristan Zing) I want to tee off the 22mm bath feed to 15mm for the shower, the old plumbing had check valves into the bath hot and cold not sure if they were double or single. Is it necessary to fit...

Hello everyone tried as suggested by Jackthom, boiler fired up ok but call for heating LED was permanently on, any suggestions please! HOPEFULLY AN EASY FIX?

Thanks for your reply that was extremely helpful!

Really appreciate some help please. I have recently moved into a new house and not familiar with my heating hot water system. Can someone please tell me what the red wheeled gate valve is for? I recently tried to isolate the hot water and did try to close this valve and I believe it was...

OK thanks for the advice. I am assuming you mean fitting Aqua board or similar products in the wet area which I am looking in to.

Hello I want to fit a thermostatically controlled shower above my bath. I have a good flow of hot and cold water to the bath and want to take a feed for the shower off the 22mm pipes which feed the bath. I was hoping to use 22mm to 15mm tee connectors as the feed for the shower. I have read...

The dot and dab is not in the wet area, in the wet area there is a metal partitioning system where the plasterboard is screwed to the frame

Thanks for responding. I have removed the bottom half of the plasterboard all around the bathroom which was tiled and will be replacing with dry wall plasterboard dot and dab on the blockwork

I am refitting my bathroom and removed dot and dab drywall from thermalite blocks. where I have removed the bonding it has taken lumps out of the blocks, some about 30mm deep, would it be best to fill with hardwall or bonding, and is there any prep needed before filling as I should imagine the...

Hello everyone. I am replacing a defective Potterton PRT2 central heating thermostat with a Honeywell T6360b as I have been informed by Potterton this is a three wire replacement. I will upload the current wiring configuration on the Potterton. I am fairly practical but I do not want to fry...