Search results

https://www.electrical2go.co.uk/jcc-v50-colour-selectable-fixed-fire-rated-led-downlight-7w-650lm-ip65-white.html

Its just below, 2.2m. But happy to upgrade the light so will go for something like this and take out the 12V transformer.

preparing for renting

Report says the light I have "doesnt" have an IP rating atall and needs to be replaced with one that does (but doesn't say which IP rating it should have). I would say ceiling is about 2.2m. Light is 35cm away from shower door. Picture of fuse box

YEs

I would like to replace the downlight in my ensuite to a new one that has the correct IP rating for its location. EICR check I has said the light was non IP rated. The current light as shown in the picture is a 12V downlight being driven by a transformer which is in the ceiling space nearby. I...

Hello. This pump was fitted 3 years ago and had been working fine. Just recently it has been playing up. If you get into the shower and turn on the taps it runs ok straight away. If you then switch off the taps for a short while (20secs to Shampoo or shower gel) and then switch the taps back on...

I unclipped the mid way valve and you can see the water leak. All pics are posted the right way up so far.

Also just spotted that the spring attachment is broken off, what does that spring do?

This RCD is tripping, currently in the good position. This morning Ive switched it on and it hasnt tripped. Also has the water pump in the circuit.

This is the leak on the mid way valve

Just touched the bottom of the mid protection actuator and there was a drop of water there. I'm wondering if this is the location of the earth leak.

My central heating system which includes the Potterton Suprima is tripping the circuit breaker. If I switch off the isolation switch ((boiler and control panel), reset the circuit breaker, then switch on the isolation switch again it trips the circuit breaker immediately. Any suggestions?

Whats the prv pipe? Is that like an overflow pipe? Check it for what?

My combi boiler tripped out this morning. The pressure guage on the front which at the weekend was reading just over 1 bar, was almost at zero. Any ideas to what has caused this sudden loss of pressure? I have increased the pressure back to 1 bar to get it going this morning, but obviuosly...