Search results

I realised that I had given very little information about the system So here are some more details: Boiler is a Potterton Netaheat 10/15 Fully pumped two pipe system fed by feed/expansion tank in loft 3 motorised valves that isolate the hot water, ground floor heating and first floor...

I'm planning to add some Sentinel X400 sludge remover to my central heating system and at the same time fit a towel radiator - I think I can get away with a partial drain After I've run the sludge remover for a couple of weeks, I was then planning to fully drain down, remove and flush each...

We have a Cannon Camberley gas cooker (model number 10308G) which was purchased in June 2001 Over the last year the burner ignition has become increasingly intermittent: sometimes they light - sometimes they don't. As a fall back, they can always be lit manually with a match I have...

Guys, Thanks for suggestions so far The taps don't move in relation to the main body, so I think I need to get a tap puller Is the tap puller you describe a specialist tool ? If it's easy can you post a picture of the tap puller ? Where can I get one ? Any help much appreciated...

Guys Apologies - looks like I forgot to make the site public It's public now and you should be able to see the pictures After making it public, I pasted the link http://photobucket.com/albums/a358/hartnellg/diytaps/ directly into a browser and got to the images Prior to that, as...

Guys Thanks for the suggestions so far Picture for this problem are at : http://photobucket.com/albums/a358/hartnellg/diytaps/

Pictures have been mailed to admin @diynot.com for this post for inclusion very shortly

I have a leaking mixer tap which I think I can dismantle once I get the tap tops removed. However, I can't get the tap tops off and need some advice The mixer tap is probably about 20 years old with a central swivel mixer pipe, with hot tap on the left, cold tap on the right. Each of the...

Hello, I have a Bosch fridge-freezer that is about 7 years old (KGV2604-GB/02) The door seals have started to split, and I have tried a couple of places to get replacement seals, but am told they are integral to the doors. It's going to cost about £200 to get both doors replaced, so this...

Hi, I had a problem with a Netaheat that was about 20 years old and eventually got it fixed - see the post 'boiler not coming on' and I've repeated it here. It may not be the same thing, but the checks are easy: Have a look at the functional diagram in the docs - as far as I can remember...

Got this fixed after getting an engineer out through my house buildings insurance, but it cost a lot. So for the benefit of others, here's what the problem was, plus some other tips: 1) the actual problem was the relay which plugs into the PCB - relays have a finite lifetime and after about...

Hello, With regard to the Potterton Netaheat not starting, I have the following additional information: Boiler: Potterton Netaheat Model: 10-16 MkIIF The cycling sequence is as follows: a) controller calls for hot water b) the fan starts c) after about 10 seconds, the pilot...

Hello, I have a similar problem with the following boiler: Potterton Netaheat - about 20 years old I think its the 30-45 model, at least as far as I can remember, it's the smaller of the two that were produced at the time This morning I got a call from home, saying that the boiler was...