Search results

Update !! New thermostat fuse fitted and all back up and running (y) I even managed to return the heater element I didn't need for a full refund. Mega thanks to jj4091for advice and diagnosis methods. It just goes to prove that with a little bit of determination, the ability to use a...

Thank you very much for your prompt and very good advice. I managed to conduct your suggested tests without electrocuting myself :sneaky: No power recorded through the plug and socket connection. Took the front off the machine and found the thermostat fuse, and as you guessed no continuity...

I do have a multi meter but would need step by step guidance. Won’t be able to do anything until tomorrow afternoon though. Thanks

All lights flashing, and the online suggestions were to change the heater element, which of course didn't work :(

I have a Hoover Vision Tech VTV581NC tumble dryer which although still tumbles all the panel lights are flashing as well as a beeping sound and no heat. I did a little bit of online research and most suggestions pointed towards the heating element. I have just changed for a genuine hoover...

Thank you very much, I will do that as the thermostat is located about 2 feet away from programmer so should be easy to do a continuity check on each wire. Thanks all for previous advice and suggestions very helpful (y)

Sorry I have not been back to you sooner. I now have time to experiment again. Forgive me if im being thick but are you suggesting I should not connect the wire I have labelled 4 but instead connect to terminal 4 the red wire that was in the connector block with the yellow? The other wires...

The cables were all marked by me so I could try and get my head round what went where by tracing them to where they are connected in the wiring centre. I marked that cable as rm stat because the red wire and earth wire went to rm stat in wiring centre, there is a third wire in that cable which...

Thanks Ian I think you are right and I have actually taken the easy route by placing the red and yellow in a common terminal and the hive is working as it should. The wiring is a bit of a mystery as to what goes where so unless someone else comes up with a definitive answer for removing the stat...

Hello good people I hope you can steer me to what I should do to achieve the above. My system is a Y plan with my boiler, hotwater tank, water supply tank, 3 port valve and wiring centre all located in my attic. I have installed hive and all appears to be working fine by connecting the live...