Search results

Hi all Hope everyone is well! I need some help as getting conflicting advice from some heating engineers I’ve had around to quote. I currently have a gravity fed system which when we moved in a couple of years ago was on a W plan, which I immediately had changed to a S+ plan. Current boiler...

I’ll check later when I’m back but sure it’s timber or plaster

Good shout, I’ll look for a metal detector. m will the panel be fixing to the wall?

Looks like it was done prior to fitting as they had fitted a flex cable which came out to the side of the chimney breast to plug into a socket. I can’t see any visible fixings for the surround, not sure how to remove without damaging plaster etc.

Yes it’s stone. The hole at the bottom in where an extension lead came out of for the electric fire they must of had there. I chopped that out a while ago

Thank you. I thought of angle grinder when you mentioned diamond as I have some diamond blades. I was thinking of a 12x18” hole for now and then the installer can enlarge for final fire as we haven’t selected one yet and not sure if it needs lining

Yes it looks like inch thick stone. Will an angle grinder work as ultimately I’ll need a cutout for the fire itself. Just need to keep dust at bay

Hi all When we purchased our current house the fireplace had been blocked up and we are now looking to fit a gas fire but need to get the chimney inspected first. How can I cut a hatch in this back piece so the engineer can get this camera up there as well as sweep the chimney? Thanks

Thanks for that. I can’t believe you can’t replace the bearings. I took off the rear cover and pulley and could see the outer bearing which is available to buy but just not sure about inner. Nothing last anymore guessing these are sealed drums

Hi all I have a Hoover DXOA610AHFN-80 machine and when the drum turns it’s happy a knocking sound. At first I thought it was overloaded but turning it by hand when it’s empty the noise can still be heard, also there seems to be a lot of play in the inner drum front to back. Any ideas on what...

Exactly what I need to do. Thanks

Thanks, I have a blower and got them in piles but was hoping for them to be mulched as too many for green waste bin collection

Hi all Looking for a petrol garden vac/mulcher as I have loads of leaves to collect. Any recommendations? Thanks in advance

I have a kewtech kt64 multifunction tester, is this what you were referring to?

Anyway to test it to be sure before ordering a new one?

Hi all When switching the smaller oven on, it trips the rcd within a minute or so. With Xmas coming up, would like to get this sorted so we have 2 working oven. Any idea what this could be or how to diagnose this. Thanks

That makes sense. If I remove local arm/disarm will that make any difference?

I’ve got a 64-w running v5.06 I’ve just tried this after work and seems to be working more like it should of. I can’t arm/disarm an area the user doesn’t have access to but when putting the code for area B into the keypad for area A it does accept the code and get the welcome message. This...

Hi all Following on from my last thread I have got my initial setup working fine and now added an additional keypad and door sensor for my shed. I have the house on area A and the shed on B. Seems to work fine but the only confusing thing is both keypads can arm both areas even though I’ve...

Hi. Managed to figure it out, somehow the panel lost the com1 and com2 settings. I’ve also got notifications working as I forgot to add arc1 value as connect. I think I have it all setup for now bar the part/full buttons. Need to get another pir & door contact so that I can fit this to my shed...