Search results

it pushes any air locks in the rad or pipework out of the way

As above turn every rad off apart from one playing up and have lockshield fully open

:unsure: :sneaky::LOL:

Sounds like they were after a boiler change out of you or highly inexperienced, adjusting a gas valve is as basic as it comes glad you have been sorted. Without spending ££££

What are classing as a contemporary vertical rad ?

Confirms he has not got a clue

Hey childish mod you forgot to remove my comment and ban me from this thread are you slipping or been on holiday ?

lol yep . Too be honest by time we had turned up usually within the hour the majority of custs had calmed down and would speak to us politely instead of how they had blown up at the person wanting to cut them off .

amazing how quickly they gave permission when we turned up and said sorry cutting you off in the street now and its going to cost you at least 1k to get turned back on .

touch it and it is gas then your leaving yourself open for prosecution

i have got column designer rads in 5 rooms and properly sized they heat the room the same as normal rads but back to the OP is it an oval tubed vertical rad ? usually easiest way is to put the top 2 bracket on first making sure they are perfect level then hang the rad then offer up the bottom...

if it is gas and its out in the path /street then you should not be touching it at all in anyway

HW light flashing is pre heat so yep certainly sounds like a passing divertor valve to turn the preheat off turn the HW thermostat knob fully anti clock wise so little pip is at the top

did he use his x ray eyes to see through the boiler casing . if you are ID ing something because you think its not right you need the figures and readings to confirm it. Meter governor knackered takes less than 30 seconds to confirm with a working pressure test and if you found that you would be...

Yep there has to be clear evidence to ID it . The running of the tap is certainly a strange one.

Failed in what way did he put working pressure and gas rate and flue gas analyser readings on the warning label....what make and model of boiler is it. Why didn't he turn heating on to get his readings ? . Turning hot tap on with a cylinder already satisfied would need a good few minutes too...

get a few of these lit and in and see if there is any seepage ...

There was me thinking notch only came across his card board Trump cut out

That is two flex grips that have not been screwed into place

the lever to re pressure is the blue one on the right lever it gets turned and pointed towards the back to open and returned to the position in photo to close