Search results

it is 2m/6ft 7" from the ground but its working out what the ground level is to measure from

no ....the natural ground level uses the term "immediately adjacent" as you may not be able to physically see whats under but because its a fence it can physically be measured from the ground level under the fence the measurement anywhere remote is off no value as far as a fence goes for what...

my thoughts ask the neighbour what would make them happy as a compromise, pointing out what actual height is required to stop you seeing over the fence by mistake or design and whilst i agree about the actual height probably being perhaps 1/4 to 3/4 below the top off the wall but how do you...

you are misunderstanding how things work a fence panel runs between 2 adjacent posts the higher off the two posts is the datum point for that panel with the next panel needs to be stepped down or at an angle as the datum point is now the other post that is now at a lower level...

the "structure" in this case is the single individual fence panel and nothing farther away adjacent means touching or within inches as far as fences are concerened

my thoughts the internet where many will shop relies on exact input for accurate results being a possibility being clouded by lack off care or actual standards by the seller for safe and long life being possible but very often standards are off no interest to the seller ------but just a thought ??

find it fix it drive it sorts that problem ;)

stopped watching when the format changed, perhaps 6 or 8 weeks ago dont forget the old classic car series he was in with 2 other people that was very entertaining and the restoration series he was also in

my thoughts you have a bar that when it fully enters the handle one side it lets go off the other handle?? my solution assuming it is say 45mm too short dowel/pencil/other item 20mm long placed in each handle before fixing this off course will only work providing around 12mm square in each...

you then have the cable holding the door open at the handle end just the wire thickness but near the hinge several inches

if its an internal wardrobe fitting then cable will be fine otherwise if its to get something outside plugged in then you need about a 65mm gap to get the plug along the wall or the cable will exit via the door at the front think off plugging in an extension to ease future use and allow more...

you choices really are to pad out or dig in the upstand do not try to force the upstand to bend unless it can flex but then just gentle pressure remember if the upstand is at all glossy or reflective bending can cause all sorts off shadows or shapes iff a light source is other than several...

the easiest way is iff the top is still loose rotate the top pivoting on the corner and move half the gap to the other wall and take it from there but that assumes its just an"L" shape and everything is in your favour ?

did you use a pin in the hole to release the mechanism for it to pop out about 5mm?? i assume its the same as my galaxy a12??

to be fair a correctly set up correctly used router is very very safe and impossible to cause harm because ---- with work in place there will be no gap greater than 6mm because all the guards required cover the work and stance requires hands at least 6" away now in the real world --- feather...

from memmory that router is a base clamped to its body type if the plastic body /clamp/base/plunge action are out off line it wont cut propely i would seperate the plastic body from the base clean them up and check they sit square and true and take it from there

not ideal but somthing like sandbag/sandsnakes placed to look like giving support to hold the frame down so wont look out off place at least in the short term

rule off thumb regular savers with a fixed monthly amount are half the interest stated as the average over the year is half the full amount anything greater than around 5% as the mentioned rate is loosing money so iff not to get your buisness you have to ask why like may only be applicable...

most off big clives was way over my head but still watched every second lol..... so next year may have much more efficent leds

martin lewis brilliant honest source https://www.moneysavingexpert.com/banking/