Search results

Which company did you use? Can you share the design? Could you substitute one of the central units for one 50mm narrower? Might be at your expense, but the cost of one unit might save a lot of hassle chopping units...

I would probably fill in the one near the corner, then make use of the one on the extension end (with a deeper worktop) to sit toaster / coffee machine / etc. As the extension protrusion is not the same as the chimney it will look odd if you infill it IMO

Yes you need an rsj to take out the breast.

We bought our utility room units from them. They get very good reviews and are very good value compared to the other big suppliers. The units were noticeably inferior to our kitchen, but that was a higher end German company, so not really comparable.

Sounds like the two valves have been wired in to a single zone + HW controller. You'll need a new controller with two heating zones ( or possibly the hot water side can just be disconnected and a new single zone controller can be added) and a new thermostat for the other zone

Definitely possible to do, but for the cost you might as well add a larger extension on.

Are all 4 receivers linked up to the same wireless thermostat by mistake?

Deleted.

There won't be a correct answer to this question, the question setter just wants you to show the logic behind the code. My interpretation would be the total length of wood required to frame these rooms (to make a wireframe box). The dimensions are labelled as "i.e.", but I suspect they meant...

Use a depth stop on your drill?

6cm??????????

How would you get in the bath on number 3? The square section of the P shaped baths is usually where the shower and screen would be

Presumably the second link can only be one or the other, while the first can run both at the same time

The pipe won't be hot in the summer if your heating isn't on ....

(Not a plumber) but is it possible the cylinder PRV is faulty / set to too low a pressure so mains cold feed pressure forcing it open and pushing out all the warming water?

Our floor is about to be tiled at the end of this week and the matching grout colour that was used in the shop is Tilemaster Grout 3000 Light Grey. Unfortunately they don't have any in stock since we ordered the tiles a few weeks ago and don't know when it will be back. Online retailers are all...

Nobody made this clear until we were looking at the drawings with builders unfortunately... It definitely sounds like we would be fighting a losing battle trying to convince planning dept that we should be able to do what is effectively allowed under PD. I'd prefer not to go with a cold roof to...

But could I not (hypothetically) build a 6m long, 4m high extension off the dining room under PD? Why would planning for a 3.4m long, ~3m high extension get rejected on the basis of imposing on the neighbours when this would be acceptable?

Hi all, We engaged an architect to draw up a rear kitchen extension on our 1930s semi, but because the original back wall was stepped (kitchen protrudes an extra 1m), and the dining room side (attached to neighbours) is more than half the width of the property (dining room 3.5m wide and kitchen...