Search results

Sparks and old birds nests !! Thing is, it could be smouldering away for quite a while before the roof goes up. Hammer and a 2" chissel is what i've always used,not for repairing mind,just when taking them down to replace with plastic.

OK I'll except your offer T2. How do i contact you for details ?

This is the whole lot of lead working tools, i would think the cone shaped ones are for opening up lead pipe to take the solder. Any other offers, i am willing to sell these. rob.

[/url] Those wooden toggles with the rope through the middle of them has got me. The big clamp, is this for holding lead pipes while jointing ? Then there's that copper gauge thing with three points and holes.

Yeah thanks for that, i was wondering how the original one was held in. Sure that's not mentioned in that leaflet that came with it.

I have the glass and have read the leaflet that comes with it. Doesn't look to hard but is there anything to watch out for,does the original pane come out easily after the screws have been removed. Its only a C02 so not hard to handle.

I have a few pairs of knee pad trousers,trouble is they don't do the biss. They always seem to be facing inwards and when you kneel down only a bit of the pad is where it should be! Can you buy a twisted knee pair where the pad comes around as the trouser raises and be in the correct...

Maybe this many. http://blogs.mirror.co.uk/asbestos-campaign/2009/03/asbestos-the-dust-of-death-set.html

Under the top where the three meet you can put a lead saddle,and even some compo.

Yes give it a go,what have you to lose, hold the ones up around with the broken ones with bits of batten then wiggle the broken ones out. Just make sure the new ones are nicely on the battens.

Just before Christmas we had a power cut,so i look outside and the house each side of us has power.A bloke over the road comes out and asked me whats going on because his was off as well. How come the whole Road didn't go off ? why is it radom like that. I phoned up the local power...

When a bloke was doing a show on how to do it at our roofing merchants, he torched on the unerlay and the cap sheet.

I've tried all over the place to get one of these,even when there is a picture of it in the book or on a web page they never have one. Its the small screw in type about 50mm in Length.Most firms have the 15 and 25w bulbs. I was wondering whether they are not made any more,some kind of...

Do you know what,it must be wonderful to be as good as you people.The people who never have a come back.I asked a question,but all you could do was take the ****.Fk u. PS I'd never wear a jacket like that.

What so the condesation is forming on the first layre of tar on the first sheet that was layed ? Only i did a valley in torch on and there was wet stains on the plasterboard that covered the wooden beams that support the center valley. I checked the joints they looked good but i torched more...

I know its a bit late but you could have used the box profile which the under side is coated in cotton. Its more exspensive than the bare sheets but thats exactly whats its for.Anyway thats what they reccon :mrgreen: The cotton soaks up the condensation,maybe it then runs out into the gutter?