Search results

So I'm getting heat to the flow then the heat is working is way up and across the coloums. But the return is only Luke warm

Can column radiators perform ok on microbore? Would be 8mm copper

Is it ok to just cap central heating pipes it's the central heating pipes to an old under kitchen plythn heater. Was looking at capping with soldered or compression caps under the plythn.

Have a piece with a small scratch on it that isn't on a fitting. Not sure if needs replacing

Would a scratch on a plastic pipe need to be a pretty drastic to cause an issue? Imagine any scratches near on on were positioning a fitting aren't ok as would allow the oring to seal

Thanks id need to solder so don't think I'd be able to do with with bunging the system? I could freeze if can get access under the floor

Are this usually hard work with airlocks of drained? I'm going to see if I can freeze the pipework if can get under the floor. Is for a couple of rad/valve swaps

What size hole do you generally core the hole for a toilet waste so it accepts the collar of the waste fitting. The same for a 40mm waste pipe, so it attempts the collar of the fitting. Thanks

Thanks if I use solvent I will have to get the pipes through to the shower tray then pipe up when fit the tray. I would have to use two solvent 45s

Would most people use solvent or push fit in this situation?

Should it peal of the wood ok?

Thanks yes I need to take the bottom panel off to get access to adjust the flush pipe

What's the best way of removing this silicone after cutting with a Stanley knife to remove the panel to get access to the toilet flush pipe for a repair. I don't want to damage the wood by scraping the old silicone off before re installing. Thanks

I need to remove the silicone around a back to wall pan. To allow removable of the panel to assess the flush pipe. What's the best way of removing the silicone from the wooden panel? Or is it just cut it with a Stanley knife so can remove them silicone over the old silicone?

Thanks so maybe best of installing a new pressure reducer?

Thanks I think this is the pressure reducer on the incoming mains. Not the one that's part of a composite valve

The prv for a house

What are the symptoms of the filter in a pressure reducing valve being partially blocked. Are they usually easy to clean out/removable?

Are universal transition couplings best to attach to lead these days? I need to attach to the lead downstream of this stop tap.

I need to renew this lead flush pipe for solvent. Can anyone think of a way of neatly clipping it in the same position can't use normal saddle clips as I haven't got a flat surface either side. One side stepped on.