Search results

Thanks do you fit alot of prorads?

Have to put the pipes in well get them close then come back and pipe the rads when the plasterer has done. With plastic I have stuck abit of plastic up out of the floor with it being flexible at the pipe centres for the rad. How would you do this with copper pipe plasterer

Just means taking more floorboards up possibly.

What do most do when putting central heating in to a home with floorboards copper or plastic?

I'm with you and you glue that together? That was the issue I was looking at some heigh level flush pipe sets and they were a fortune

Would it be possible to make one of these out out 40mm solvent weld pipe?

When swapping a high level cistern. Do people usually swap the brackets too. Notice this are sold separately. Thanks

Was a pipe that goes through to the garage I cut the elbow off at the bottom and sleeved it properly

Plastic pipe

Is there anyway if sleeving a cold water pipe that is already in place through an air brick. Without cutting the pipe. Thanks

That's flat so would be flat washer?

Maybe just a bead of silicone here then?

Thanks yes alot of taps now have a fluted end so you could connect on with a nut and olive? Though be hard to get enough force to tighten with a tap spanner

Usually throw top washer and use silicone. Not used one of these one piece washers before

So maybe just silicone on the bottom bit were it meets the bottom of the bath?

Guess it depends if the tap face is flat, then id if the flat washer. If it tapered, alot of taps seem to be now. Id fit the concaved washer?

This type

If using Hep2o plastic tap connectors, do you use the flat washer or concaved one that comes with it.

Thanks to me it sorted if looks like it's been gone over with a brush. SBR bond the surface before apply the mortar to match the render?

Thanks how would you roughen it up to get a similar effect to what's in?