Search results

That's the style of shower so they usually have check valves on the hot side? Or must likely the cartridge?

Thanks I'll try and ask the manufacturer if there is any check valve in the shower

Sorry I'm getting flow of water just no heat when turn it up on the temperature knob.

The dimmer switch is about 15 years old did they not used to work with led lights?

Thanks. I'm getting nothing at the moment.

So I would need a non led. Dimmable bulb? If thet make these.

Is this usually the cartridge on the temperature dial? Does it just stop letting hot water through? Thanks

Any idea why a dimmer switch is constantly giving flickering lights even though I have fit dimmerable bulbs. Have attached a photo thanks.

Thanks yes the captive ones with the oring do look cheap. The other type are machined so good they don't need the oring to seal?

Was going to go with the mcapline clicker bathwaste and basin

Push plug clicker?

Cable that operates by moving the overflow?

Which of these two is the preferred method the push down clicker waste for a bath or the type were you turn the overflow. Thanks

If fitting one of this on low pressure is it best not to fit the flow reducer?

Is it ok to stick plastic shower panelling in to plywood. I think it's water and boiler proof. I planned on priming the plywood with SBR bond

I'm not sure if it is would you be able to tell by seeing a picture of it?

I've been given 600mm wide shower panels to install in a 800mm shower enclosure. This is a bad idea as there will be a joint on each wall to make up to 800mm it's the wooden panels. I have before used the plastic stuff that comes in 2.4m x 1m lengths

Thanks then my timber uprights on the wall I should make at 400mm centres?

Thanks is it unlikely it could be anything wrong with the dimmer switch itself?

What's the best way of finding the joist when securing the top plate of a stud wall to the ceiling? Thanks