Search results

I was hoping that wouldn't be the case but thanks for the reply, I'll get a joiner to fit it.

Can anyone tell me how this weather strip works? As you can see it's in the middle of where the door shuts. On the side the door is supposed to shut to it has a soft sealing strip and the other side is hard plastic.

I've done it thank god!! Been at it all night the problem was I never unscrewed the pump screw and pushed it aside enough to let the air out. Amazingly only a tiny amount of air came out but obviously enough to air lock it.

I have just replaced the gate valves on either side of my water pump and had to drain the system down. With new pump and valves installed I bled the rads and the pump. I struck up the boiler but now there is air in the the pump. All the rads run fine and are full but the bleed screw on the pump...

Suppose it could be if I hadn't taken up the socket with the power shower pump :?

I am now certain it's the pump, I disconnected the pump and connected to a extension cable and it blew the RCD. I then fired the boiler for a couple of secs and it worked fine. Oh and pump went and sparked big style on low settings :o I have a weeping pump valve just above it which I need to...

My immersion heater element broke sometime ago and I never bothered to replace cause the boiler is a lot quicker. I currently use the immersion heater socket for my power shower with a low amp fuse in.

Thanks, I currently have a grundfos 15-50 pump so would like a similar quality pump. The heating was fitted by British Gas so it has quality components like honeywell etc. Anyone know any good cheap brand pumps I could check out? I have a Grahams and a plumb center near me or I could travel a...

Thanks for quick reply by the way :D

Boiled four kettles which put about an inch in the bath bottom tonight Brrrr.

Yep the valves do look like that. I suppose I should have guessed by the way the pump blew the RCD when either hot water or heating was put on :(

Hi, I'm on a gravity fed conventional boiler setup with two syncro valves and a pump. My pump has just packed up would I be able to disconnect the pump and just use the hot water and not the heating or does the hot water require the pump too? Reson I'm asking is if I need the pump for the...