Search results

no error codes. If I press the live monitor buttons I get S.30 but I assume that’s because it’s stable and not asking for heat. If I turn on heating that code changes to S.02 then boiler shuts down after 10 seconds normal codes

ah sorry that would explain it!

No pilot light on either. As soon as hot water is demanded boiler shuts down If I demand heating. Something runs for about 15 secs then boiler shuts down

Ok. Bypassed the wiring and connected to mains supply. Pump is running fine. Usual hum you would expect boiler is stable but shuts down when hot water or heating is demanded

Ok. I Can try that. So just remove the wiring in this box on top of the pump and connect some flex with a plug on. I have a 3amp fuse I can use

Thanks. Checked that. It moves fine

Boiler dead this morning. 240v going in ok. Checked pcb fuse and ok. not getting continuity across the pcb fuse holder though. is this a duff pcb or something else? UPDATE. Managed to get boiler back on but it cut out again after a couple of minutes. This time the pcb fuse has blown...

Thanks I can’t seem to get the shower mixer apart. It’s a non bar type one

Ok took the hose off. Looks ok. Turned the shower on. Kicked out boiling hot after a few seconds then went to warm and stayed like that

Ok will check All other hot water is fine

collapsed?

only the head

sorry forgot to say I took the head off and it’s the same

Triton mixer shower, non bar type is no longer hot even on full temp setting. Any ideas what could be the issue. I can’t seem how to even get the parts off to take a look.

yeah I disconnected the cable from the booster end and the socket end and tested for a short and it was clear. Put it back together and it was working fine but then today it started the poor signal again.

Right. Problems again. signal very poor and bit error 2000 showing

Dulux paint. The ceiling was skimmed a few years ago and you can see trowel marks on it. I can live with that but the brush marks look crap

ah bugger. Just a normal cheap brush really. To be fair the whole ceiling looks crap

I have recently repainted a ceiling but didn’t roll over the wet cutting in brush marks with my roller. Can i repaint over them? Will repainting cover them? Best solution? Thanks

Ok not a short on the cable but the socket was shorting so remade that again. remade the other end plug again and so far so good.