Search results

Ok, that's great, thanks a lot! Got in there and set the volumes successfully :) Do you also know if it's possible to change the volume of the confirmation beeps, when Setting the via the remote fob?

Can anyone supply me with instructions on how to lower the entry/exit volume that comes out of the main panel when entering/exiting? It's currently deafening levels, and there's no way you could come back late at night without waking up the already sleeping household. I've got the engineers...

No, I didn't - the old thermostat is still on the wall :( I removed the thermostat off the wall, connected the yellow and red wires together temporarily, and then tested various red and yellow wires in the junction box for a circuit - no joy. At that point, I gave up. I recommend you try the...

Heating system wiring diagram by gsf600y posted 3 Jun 2017 at 12:15 PM I've created a diagram of the wiring in the airing cupboard. Can anyone help me work out how to correctly disable the wall thermostat? Should I just disconnect all it's cables in the choc-block, and the move the white cable...

Hi, Resurrecting an old thread, as I've got the same problem. Basically, I want to know how to correctly remove the old wired thermostat. Here's the wiring behind the thermostat: Danfoss Thermostat wiring by gsf600y posted 1 Jun 2017 at 12:02 PM There's 2 wires used, and the blue and earth as...

Damn, I brought the wrong thing!! Sigh. That's very annoying. Oh well. The LED strip I've chosen uses 21 watts, as measured by my smart plug anyway. I figured if I'm running 3 in a chain, I'd get a driver around the 70 watt mark, and fixated on that number, missing the DC bit. I'll get...

I'm putting 3 x 5metre strips of LED's into my garage. I'm going to have the LED driver wired up to a connector block, which will then connect to each of the 3 LED strips.....pretty much like this: The input connections on the drive are well covered. The output connections could are...

well, ifttt is possible in a limited way, I've done that already. e.g. alarm goes off, I get a text message from Enforcer. that triggers ifttt to turn my lights on. but I want something a bit smarter now.

Hello, I'm wondering if I can hook up my Pyronix Enforcer to my home automation. Are there any kind of outputs on the Enforcer that can connected up to some kind of i/o module or sensor, which can then link up to my hub. I've got a Samsung Smartthings hub. I'm thinking of things like...

I'd noticed :) My popcorn has run out.

It's 80-90°c, not F. I noticed it after installing, and checking for leaks whilst the pump was running. Put my hand on the casing, the middle section, it noticed to was too hot to touch. I emailed the pump maker. they replied with: So, yeah, it's hot alright. Never did feel the old when...

OK, thanks to everyone who's contributed :) Learnt lots fitting this pump :) The pump get very hot, 90 degrees, so that's a ceramic floor tile under it, which I thought was better than wood or carpet. noted regarding the cable, and fixing properly.

Photo of the socket in question. So, don't know if it makes a difference to the debate, but if I'm the only person using this socket, and I'm not likely to plug anything else into that socket (bar perhaps a light whilst I'm working in that area of the loft), it sounds like it's safe. This...

OK. googling that shows lots of round pin sockets..... I've got a pump with a standard plug on it, with a fuse in the plug. Can you explain what's wrong with a normal socket faceplate? thanks :)