Search results

Thanks very much for your help, I will get the electrician from work to do the tests you mention. i will post results as it may help others. BR

Yes i have a multi meter. The stat has T70 on it and the wire goes to a large white box(Randall) Thanks BR

The hot water is controlled by a honeywell timer, although evan putting it on continuous does not work. There is a stat on the cylinder, its white with a black dial which sits it a hole cut in the jacket set at about 55. Thanks BR

My ideal classic in the kitchen fires up when the heating is needed but if the hot water is required the boiler does not fire. The honeywell timer switch lights when put on continuous but thats all. I can get hot water if i use the imersion heater. Any ideas please Thanks BR

Cant see a cylinder stat There is a room stat There is 1 motorised valve which seems to work When central heating is switched to continuous I can hear the motor start to hum, but don't think its pumping because it gets very hot. So the central heating is not a sealed system like a combi...

Thanks for the last answer How is the CH system filled, there don't seem to be any filling loop? Thanks

A system by brother is not used to is in his new house. It has a back boiler, which says Baxi on it, 2 tanks in the loft, one is sitting on the joists the other is higher on the loft wall. There is a tank in the cupboard which heats the water but the cetral heating does not work. The pump is...

I have a multimeter, can i test from the electorde? Is the 3mm gap ok? Thanks

cant see any shorting and electrodes look clean. The gap is 3mm. Not sure if they are using the same spark generators havn't got that far yet. The cooker is a Leisure Rangemaster 110. Thanks

When i turn the oven on my range oven does not always spark to ignite the gas. The gas is coming through but the auto ignition spark does not always work. The gas rings are fine, they have a button to press for ignition. Tried cleaning the electrodes but still same thanks

I think its the motor, its quite stiff and it only frees up after a squert of WD. Any used motors available? Thanks for the replies

Thanks i can see the main pump motor, which is very stiff to turn but how do i get to it, does the base come off easy? I want to replace the circulation motor Thank you

Any ideas if the base is removable from this machine, any hints. Thank you

does anyone know how to remove the tub from a bosch srs5602 slim dishwasher please. Its to gain access to the motors. Thanks

The chimney from ground floor was removed 30yrs ago, if a support is now put in place, does it require an inspection on completion by the local council? Thanks for your answers

Not an option to remove the whole chimney. Does a cantilever chimney support need to be as deep and as wide as the rest of the chimney above. Thank you

A chimney breast, which was in the corner of the room has been remove from the ground floor but not above it. Does a cantilever chimney support need to be as deep and as wide as the rest of the chimney above. Thank you

Our bosch dishwasher is not washing. All the right lights come on and the timer counts down but the normal washing sound is not there, if I open the door after a couple of minutes all that has happened is the bottom of the washer fills with water but no water has actually been sprayed on the...

the earthing in question comes from a wall socket next to the boiler. The earth cable actually goes up into the socket housing and is not connected to a plug. Also only goes to 1 heating pipe on the combi boiler I ask because on my old house it was slightly different and wanted to make sure...

Can an earth strap for cetral heating pipes come from a wall socket on the ring main or does it have to come from the main earth in the fuse box. Thank you