Search results

The basement is half under ground level and half above with the only low level area being where the entrance door is which is down some steps.i think it probably will be best to get someone in to do the work at least I will know it is correctly. thanks for the replies mark

I now that you have to be corgi registered to work on gas boilers but this is not what I am doing it is merely that an engineer came to do the yearly service and stated that the ventilation was now inadequate and needed sorting out which as I am an ex-british gas engineer they asked my advice...

I managed to find out it is an ideal Concord C290 series 2 gas boiler rated at 295,000 BTU or 86.5 KW.Now according to my calculations the requirements at high level would be 330cm sq and at low level would be 660cm sq using a guide of 270cm sq plus 2.25cm sq per KW in excess of 60KW for high...

Recently our club had its yearly boiler service and the engineer stated that we needed more ventilation but he did not state what we required .We have an ideal concord C series 2 gas boiler but the identification badge seems to of come off so I cannot say what the BTU's are.It is a convential...

The machine drains quickly and i have checked the pipes to the pump all ok.Everything seems in order but it just sometimes has a couple of centimetres of water lying in the drum after the drying cycle(have checked drum is empty of water before putting on drying cycle)It is probably just one of...

The heating element seems to be OK and working as where it is situated it does get hot and it is not blocked neither is where the warm air goes into the drum. I have cleaned out what I think is the condenser (connected to the fan and an outlet to the back of the drum and also the rubber u-...

Yes the clothes are "dry" after the normal wash cycle and spin.It is when they are on the drying cycle that they sometimes get wet but not all the time but it is becoming more frequent.

My hoover washer/dryer when on a drying cycle leaves the clothes wet this happens quite often now and seems to be getting worse anyone got any ideas of what it may be causing this problem.

Breezer spot on. The grey hose was blocked right at the end in the waste pipe. many thanks mark

I fitted a new pump only a year ago and I took it out yesterday to check it seems ok.I also cleaned out what is probably the filter which is located at the front of the machine. I have just put it on a setting which is a short spin (about 6 minutes) which should drain out water but the water is...

The drum had water in it when it finished a wash cycle so I drained it out so i could open the door i then put it on a drying cycle for an hour it goes through its checks then starts to work,halfway through it stops and the timer counts down with nothing happening so i shut it down but it will...