Search results

can i change my existing light in the kitchen for 5 or 6 50w down lighters all wired from a hd jbox ie 1 cable for each fitting.would this have to be part p approved or is it non notifiable.thanks in anticipation.

could someone please tell me where the central locking relay is located on a vaux vectra 1.8 petrol. on a 2000 plate.and which 1 it is.when activated with key fob,lights flash but relays do not engage.thanks

could anyone advise me the best way to keep an eye on my car.in a 4 storie block of flats.cctv would be attacked by the local yobs.video or the like from inside the flat is where im looking at.can anyone advise of a suitable system...with thanks.

took your advise,rgi.now sorted.with thanks.

i have electrical/electronic exp.any idea what values im looking for and where on pcb.many thanks in anticipation. 8)

are there any checks i can carry out to identify the problem.? be it a.p.s/p.c.b.etc.if its going to get too costly,thinking of complete replacement.already cost for new fan,ignition electrode,lead.approx 14yr old.appreciate the help.

can only see one tube on pressure switch not two.?

baxi solo2 50pf.boiler start up ok fan runs but no spark to ignition.suspect faulty air pressure switch..any way i can check it to make sure.

i have a baxi 133 he,had some work done recentlyboiler had to be taken off the wall,secured then put back.on refitting the lead to the gas valve was inadvertantly disconnected,the system would then not fire up,on noticing the connector plug was not located properly.proceeded to plug it back in...

i would like to alter 2 4ft wide windows, and replace with 4ft french doors opening inwards with juliet balconys on outside wall.i am in a council flat 1st floor in a block of 3 floors.i would love a balcony to be able to sit on,if that is possible.please point me in the right direction initally...

i need a new supply to gas hob.can i put a pipe in the floor.concrete.

pressure seemed ok at 1.3 cold, rising to 1,8 hot.

the rads were fitted by myself pretty stright forward,just took the old ones out relaced with new.and 1 extra in garage.the blue pressure valve was accidentally turned by mistake,thinking it was pressure relief valve,would this make a difference.

the rads are heating up fine no prob,as soon as anyone turns a hot tap on,the boiler gives hot water,then wont do anything else until i reset the boiler.its as if someones told it to stop the heating process.

recently had new rads fitted,all balanced working ok.call for hot water and boiler stops.it will give hot water,but wont go back to heating.have to switch off and on to reset.then a call for hot water have to reset again and so on.boiler is a gloworm xtrafast.any possible causes remedys.thanks...

not sure about the primatic label...lokks like a standard hw cylinder.

yes,let the cold tank fill to almost overflowing,water went down the 22mm pipe,got the pressure back in the rads.managed to fill em all back up.there is a 22mm vent pipe(inverted u shape ) present also from hw. the only output from the cold w tank is to bottom of hw cylinder. should i fit a...

definitely no header tank.the filling pipe for the c/h.is in the cold water tank approx 20mm below the ball cock fitting.never gets any water because the ballcock shuts off way before the water level gets that high.

Help needed,rads not getting hot upstairs.tied to bleed..no pressure.up the loft to check header tank...no header.checked the cold water tank.the filling pipe is way above the water level.about 20mm below the incoming valve.suggestions please.the system is a old back boiler/gas fire.thanks in...