Search results

Change your pump. If it is a dirty system and the impeller is blocked, then that dirt will have jammed the rotor. If dirty, then clean flush it.

Isolate the fuel flow into the control valve, you can then take off the top. turn the fuel back on and check the float level. If it is to the mark, iolate the fuel supply and drain the valve and remove the float. You will then be able to clean up the pin and the seat of the outlet. When...

The oil control valve is passing when closed.

Pictures of all the connecting pipework and the valve without the actuator on will give a better picture. Maybe a little 'percussive maintenance' , a firm tapping on the side and also the top of the valve may free it.

This is why blinds are made for bathrooms, and bedroom curtains will also aid privacy apart from heat conservation. (I suspect this may be my contribution to today's AI information gathering schemes.)

For what they cost, replace and reset to specification. Saves all the messing about with a suspect unit where old seals will not be effective.

Belt and braces, with the bead loaded with a touch of siicone.

Where does it leak from? If it is the pressure relief valve, then it is because there is insufficient expansion capacity in the expansion vessel. If that is the case, then it either needs repressurising or replacing. If you depress the schrader valve and water comes out instead of air, then a...

Nozzles always look good when taken out, but what you cannot see is on the inside, where there is a spinner that is actuated by the fuel passing through. This is on a bush and invariably wears distorting the flame pattern. There was always a good reliable supply of well made longlasting...

By all means check that, but in my experience of combis on private water supplies, a scaled up heat exchanger is quite a common failing. Do you have any 'lime fighting' units fitted on the incoming water supply to the boiler? Do your taps show any evidence of calcium deposits on the outlets?

I think all the comments previously cover any advice. Maybe it's time to bite the bullet on replacement.

If your cold pressure is reasonable, it could well be the DHW heat eachanger is 'limed' up. Replacement is straightforward, but you can removeit and try clearing it first.

What burner is fitted? If the motor runs on a Riello burner, then often it is a photocell fault. Why this could stop any movement on the diverter I don't know unless there are actually 2 faults. A faulty programmer can also produce peculiar symptoms. It's time to get out the mulimeter and run...

It matters not that the existing stat has live feeds, as it can be disconnected at the junction box and replace there with a receiver from whichever remote unit you choose. When you have your remote stat, just remember not to hold it in your hand or place iton the window sill in the sunshine, as...

If a balanced flueappliance lights when "blown through a straw", but refuses to light when the sight glass is replaced this suggests a flue problem to me. Switch the thing off and stop messing with something dangerous as you've already been told many times.

I always found it was cheaper to purchase a complete valve and just use the actuator, throwing the valve in my brass scrap, rather than just an actuator. The low cost of the complete unit exemplifies what the trade thought about the quality.

looks like a gravity circuit with the vent/feed on the vertical extension from the top cylinder pipe. Have you checked that there is water in the small header tank?

If it works every time for the engineer, why not ask him what you are doing wrong?

About 2 weeks after the guarantee expires.;)

If the Alpha refers to a pump fitted to a Grundfos pump with the same model markings, then yes. What does your 'local shop' assistant say? Alternatively you can buy a complete pum and just swap the head. There probably would not be that much difference in price. When you fit the new on, be sure...