Search results

Walk test no works. I checked my pir wiring and I had the alarm core on the outer connector of the two and it should have been inner. Pir now working. last issue I have is the door mag I've wired it to the rkp and mapped it to an zone not being used in the panel but I think I've got my...

Ill switch it and check it in the morning.

No I've put wire through tamp and bell as suggested in 2nd post should it be 0b instead. ??

No it still says bell tamper has all the time I've had other errors but solved them one by one This is the only remaining error

Yeah forgot at first but got system error and then linked out no more aux tamper error

Yeah entered engineer code menu twice alarming menu the. Reset faults. I've also reset to default since linking out. I'm sure I'm missing something obvious. Debating getting the USB and progaming it that way

Hi yeah I've entered the code and pressed reset all reset faults in alarm mode, The pir have got power (red light) and activated when I unscrewed the case on one the other day I've defaulted the setting a couple of times now no look I've actual reset it after linked bell tamper and...

I've linked them out using a blue wire off cut from the alarm cable and still getting bell tamper on system alerts and no zones showing on walk test

Thank you thought about doing that but wasn't sure if it was same as linking the zones Thanks again

Would anyone be able to help me. I've wired in my new alarm set zones etc and now want to test before connecting the bell box. There's is one system alert on the keypad "bell tamper" would this be the reason it won't let me do a walk test. When I've tried it just says *none* I've check...

Hi, so following on from post I've re run all new cables to pir and door connects. They all come Into the panel on seperate 6 core wire. Any advice on joining all the + - together there will be 6in total and i was doubling up the wire as I'm using eol double pole. Thanks

Thanks so I presume I need a junction box for each of the pir and door connections so I can run them all back seperate.

Hi, I'm putting a new system in and when I've traced the pir and door connects back they are all connecting to one 12 core wire stuck together with tape :-0. I was gonna connect the individual zones back up and run them seperate into the panel. Any advice on best way to do this...

hi we have lead flashing that comes out from under the window by about an inch. i have resealed it on the outide and insulated the wall on the inside but the flashing is wet on the underside. i'm relucant to start the plastering until i can find the problem can anyone help?

can anyone advise how i install a vapour barrier on the pic? kingspan is going to be fixed inbetween the rafters and down as far as the the top of ground floor bay window, how do i seal the vapour barrier sheet, do i seal it at the floor board height, (dont think i could reach any further down)

re insulate bay

I'm insulating a cold flat roof above a bay leaving a 50 mm air gap. The roof is old and isnt breathable felt there are no vents in the facia either whats the best way to add ventlation as there is no sofit? Thanks