Search results

Sounds good, Will try tonight. Thanks.

Great, but how do you get around (when using corner trowel) getting plaster all down the dry angle! Or do you do it when the plaster has firmed up but is not fully set?

Hi, Can anyone give me any tips on how to get perfect internal angles between walls when plastering? I have a corner trowel but when I put pressure on to form the angle I always end up with a line down the wet wall. Am I not putting enough plaster oon the trowel? pressing to hard??? i'm not...

Can anybody help? I have been helping out a friend and overskimming his house for him, he has stripped off the paper in all the rooms and there seems to be some kind of paint which has been used (mainly above the picture rail) which seems to be reacting when I start skimming it! so whats...

Great, could u describe how u would "Roll" into the joint to create a curve??

Hi, I have a small question, I am boarding a firends barhtroom this evening and then skimming it tomorrow, but at the top of the wall it meets the apex of the roof line (about 45º). Whats the best way of filling the gap created by the board and the ceiling? should I create an angle at the top of...

Your right it is a new tap with the small flex conections but there the same size as the ones on the bathroom tap which is fine. The cold is quite slow too, there are service valves on them but there fully open. It is a mixer tap, there is a mesh type of filter on the end, could this be...

I have a had a full new central heating system installed in my terraced house, including a new supply direct from the mains. The supply comes in via a 22mm plastic pipe and is connected via the stopcock then to standard copper through to the combi boiler a Glow worm 30si, from here it feeds the...