Search results

Hi, I stripped my hall walls then sanded and washed down with soap water. I then did two coats with Crown Magicote matt emulsion. The things is there's bits all over the surface of the wall. The tin is new but was kept outside in the garage, but I can't see any bits in the tin or on the...

Nice one Lectrician. It was the bloody energy saving bulb. All work as it should now and to hell with the environment! Thanks a lot for all the replies.

Sorry, updated images here. http://bayimg.com/mAjocaABf http://bayimg.com/MAJoEAAbf http://bayimg.com/maJOGaabF The reds haven't been moved and it was working before so I'm a bit dubious to move them tbh. I have a three core cable - live/neutral and switch wire.

They not al la mode or something. It's what was there when I bought the house.

Hi, even with the yellow in (what I think) is the right place , the fan stays on continually. On the fan there's a pull cord on/off and if I use that alone then the fan does go off. Any ideas? Thanks

yes,,sorry have since moved the yellow ( i thought it was an earth) to the left hand block ( switched live) It was a while back but possibly the yellow i mentioned or the left hand side black. Pic here http://bayimg.com/FAJoGaAbf

Hi,, the light went in my bathroom and after checking a wire had come loose. I put it back where I presumed it should go and now the bathroom extractor fan is permanently on. I did then have a look and see if I had it wired to be permanently on but i think its ok. So maybe the timer has just...

pretty sure its this one http://www.heatingcontrolsonline.co.uk/danfoss-randall-hs3-22mm-midposition-motorised-valve-p-285.html

Hi, it's a mid-position valve and I think it says Danfoss on it ( difficult to make out)

Me again. The valve is the issue. CH worked fine so set the timer to have it on this AM. It didn't come on and I had to use the manual/auto switch and then it went on fine. If I am going to open up the valve, what should I be looking at inside to check? Thanks

Mate you are a god send. I had been fiddling around outside near the boiler. Had a look in the airing cupboard and found a box saying auto/ manual. Flipped it over to manual then it slid back to auto. Tried the CH and it fired up first time. w00t, I'm going to enjoy the tropical heat. Thanks

Right, got my hot water cylinder with my thermostat on (set to 70). Where abouts would these valves be? Thanks for the assistance btw.

The room thermostat is on full, but as you say could be broke. Re the valve, I can't hear the boiler do anything when I switch the CH heating on.How would I check if the valve was openin? Any ideas how much either would be to sort? ta

Hi, in the last few days the CH has started to refuse to light up. The HW works fine, but even when I switch boiler to CH & HW, the CH doesn't work. Any ideas what it might be so I don't get over charged by the engineer? Thanks