Search results

Ok heres my problem I recently had to drain my central heating system to replace a leaking rad, I have refilled the system added inhibitor fully bled all the rads and all was fine as before but I am now getting a loud gurgling noise from the small copper header tank when the central heating is...

Bump

On hot water it runs normally it only does it when CH is on. No it doesn't have the high and low switch.

My boiler is doing my head in :evil: :evil: when the CH is on the boiler continually starts and stops.It fires up, runs for 55 seconds then stops for 40 seconds then runs for 55 seconds then stops for 40 seconds and so on CONTINUOUSLY!!!!! :twisted: :twisted: It is a Glow worm...

All the rads in my house are red hot except the lounge, this one is stone cold at the bottom and hot ish at the top. Anyone help?? the missus givin me grief cos it's freezin??

Yes the 3 walls are stud with plasterboard and a plaster skim, there was quite a bit of the plaster missing when the old tiles were removed which I asked the tiler was this a problem and he said NO! As regard to the tanking (of which I have never heard of) I don't think the tiler did this...

Ok chaps here is my problem, had my ensuite bathroom and tiles ripped out and re-fitted 6 months ago, I noticed a couple of days ago a damp patch on my kitchen ceiling (en-suite directly above) so after investigation realised it was coming from the shower, it is a square alcove shower cubicle...

I had a new kitchen fitted last year and the new hotpoint hob extractor I had fitted is a real pain, it has two 40w lights and every time the bulb blows it takes the PC board aswell.I have had two new pc boards fitted under guarantee and two months ago hotpoint replaced the whole unit for a new...

Ok here are a few pics The third pic is a top view and as you can see the two tile are touching leaving around 1mm for grout.[/img]

Thanks gcol, he is coming back tomorrow and I'm going to tell him to take them all off and re-fit them with the correct spacing.

Will he be able to remove the tiles without breaking though?

I have had my bathroom tiled today and I am a little concerned at the gap between the tiles.Some of the tiles are touching each other (no gap) and the rest have a 1mm gap.The tiles are 4" x 4" and I am worried I will not get the affect I am looking for once they are grouted as there will be very...

The valves are fully open and I have bled all the rads in the house I am the first owner and like I said before all the other rads are red hot just this problem one!

All the rads in my house are screaming hot except the one in the lounge which only ever gets warm.Does anyone have any ideas what the problem could be?? The house is new build eight years old.