Search results

hi rf. weve fitted a few of these. we try to get em on the chimney if poss. you must check the planners though. some areas wont ave em. when we fit em, we run the coax and terminate it then call a local aerial installer to set the dish to pick up the signal. £20. dont let the coax sit on the...

thanks for the quick responce. that was what i thought. i noticed 3 departures under the stairs, but no mention of them under comments. bs 951 clamp to lead sheath. bonding clamp to gas fitted to suppliers side. no safety, do not remove labels.

quick question. when the consumer unit is replaced, what do you have to do in the way of testing and certifying. do you have to test every circuit and record this on an eic. ie, R1 + R2, insulation tests, efli, etc, etc. ive just built an extension for a neighbour. he had a sparky in about 6...

the door frame most definetaly needs to come out and the cill replaced. chances are you can get i to fit. wickes sell them.

some lintles are pre stressed and normally have TOP written in the concrete. on the other hand the ones from wickes are just normal without any markings. if it sais top on, then top goes up. otherwise, n/a.

oh, and if the club hammer keeps bouncing off. then get a sledge hammer. put loads of dust sheets between the bath and the walls and floor. you will end up knocking the bedroom walls down otherwise. and, no we aint pullin your pi55er. cast iron is tough as old boots.

and dont forget to take the pictures off the walls before they fall off. bash it hard near the taps. this is one of the weaker points. dont forget your 3 weetabix either

when we build extensions with pitched roofs, we ALWAYS put 100 rockwool between joists and 150 rockwool across the first layer. the second layer is layed at 90 degrees to the first. this is accepted by our local building control office. (welwyn and hatfield. hertfordshire.)

for opening windows, its known as hoe and heel.

another valid point.

more to the point, how comes you got a survey done bryan? the surveyer is only doing his job. and correctly if there is no up to date pir. imho, for what its worth.

its well overdue for a pir, but, as jack said, why has he got to cough up. home sellers packs aint in yet.

?

very good point.

the height you are thinking of for sockets is 450mm. but, this is when you fit new sockets and is only applicable to new built houses. there is no height for sockets if you are building an extension or are rewiring your house, etc. it is advisable to fit new sockets at least 100mm from bottom of...

i done the niceic test and inspection course just before xmas. it is designed to get you up to speed with your testing and inspect skills. there is no exam at the end. all the guys on my course were sparkys, kitchen fitters, etc, trying to prepare for the assesment date. 2391 is tooootally...

osg. page 84. para 4.

hi, could you be more specific as to where the gap is. is the actual sash out of square to the frame? or does the sash not pul up to the frame properly when you close the window. hope this makes sense. :?

just leave em mate. they will shrink back to size. :wink:

careful what you do with the lime though. they used to use it to rot corpses when buried. horrible stuff. plasticiser may be safer. (unless you drink it beermonsta.) :D :wink: