Search results

i thought as much. thanks

I have some small split faced tiles which were extremely expensive, left over from another job. the tiles are a mix of materials, some of which are natural stone. i would like to make a feature wall in my new walk in shower but due to the unevenness, there is no way i can grout these tiles. Is...

i have had this before. as mentioned the outlet was oval. the pan was replaced under warranty but i did also buy a pan connector with large jubilee clip which solved the problem

what do you call proper plumbing? my unit is plumbed exactly as any separate unit would be. just contained all within one unit

victoria plumbing. generally, i wouldn’t touch victoria plumbing with a barge pole but you are very limited in suppliers for this. And actually mine is ok

the earth wire was being used as hot water off. that needs to be in terminal 4. i guess the old room stat if it has one has been disconnected/bridged out in wiring centre. if there was a room stat. that cable could be connected to the heat link so the nest doesn’t have to be plugged into a socket

i’ve fitted a couple and have one in my house. i wouldn’t fit one in a main bathroom but in a cloak room or where space is tight, i think they’re great. the parts are fairly standard in my unit so i’d have no problem sourcing spares

should work with links in

as above. needs links from L to commons

in all honesty, i can’t see the lintel being affected but i’m no expert on that. however a plume kit will resolve the flue placement issues quite easily

frozen condense. try to thaw it by pouring plenty of warm water on it

some fittings have tapered threads. some have parallel threads. if you must use that brass union that joins the braided hose you should use a copper to iron adapter to get back onto copper before the isolation valve

i think you’ll find that old&bold was implying that you’d be entitled to same day response if you were an approved installer

heat exchanger will be blocked. those heat exchangers get blocked very easily. a powerflush won’t clean it either. you’ll end up changing the heat exchanger i suspect

don’t the linea have a tap that has several positions. one for filling then one for letting cold mains through

does that mean that it wouldn't run properly? i don't use wilo pumps generally so unsure of settings

who fitted the pump. it is the fitted the right way round? what speed is it on? it looks like a wilo but unsure. don't they normally have a setting to purge air in the case of an airlock?

it seems in my area the dvla have outsourced untaxed cars to a clamping company. i've seen many cars clamped and then removed a week or two later. in fact a local car dealer had three cars parked on the street, all next to each other clamped and removed only recently

pilot drill from inside to get correct position then core drill from outside. normal practice

your issue maybe the 3 port/2 port valves if the nest is working ok