Search results

The shack is about 10 foot away from my brick outhouse. In between is a big gate that is constantly in use with my motorbike and trailer coming in and out with some quite tall objects being in the trailer. The floor is concrete. So having the plug and socket setup would be ideal as I cannot run...

Why can you not use the 32a socket etc setup?

That was the type of setup I was thinking of, from in house cu to the socket, then plug in to run small cu in shack when need. Only a small compressor being used and will probably not use welder as advised.

Confusing me now guys

Hi all, I think this might not be possible but I will ask all the same. I've created a shack where I'm restoring a car. What I want to do if possible is run armour cable from house consumer unit to a water proof plug outside which could be used to power the cosumer unit in my shack, and when not...

Thanks for the replys what are your thoughts on lenovo's??? Jim.

Hi all, I'm looking at buying a laptop for my daughter's 16th. I'm after something that's more capable than it's going to be intended for. I don't want it freezing and locking up like I've experienced before. Maybe something in the lines of a gaming laptop as my son has one and it's been...

It'll need pairing, you'll need a auto locksmith to program it.

Check the aux drive belt, it could be shredding and if it gets wrapped around bottom pulley it could work it's way into the timing belt causing fatal engine damage. Also can rip out the crank sensor and/or wiring. If it is the belt it'll probably need a new tensioner fitting also.

Well I've gone for the split spidle handles as this will achieve what I'm after. The only reason I want it like this is when I'm in or at my van going in and out with the incorrect spanner for the third time. But at night and if I am away from the house I shall lock it with the bolts over. The...

Cheers for the reply lads, it’s a Yale locking system fitted and it looks as if will take the split handle setup. The handles are broken so I will be buying a pair of the split ones an we’ll see. I’ll post tomorrow with the outcome. Jim.

Hi all, I've just purchased a used Everest porch upvc door. Fitting all went ok. My problem is when I shut the door I have to push the handle up and use the key to lock it every time I leave the house. I want it so when the door closes it carnt be opened without the key from the outside. Will I...

Hi all, just found that my boiler had gone out for some reason, possibly due to the very high winds blowing back down flue.Re lit the pilot with no problem but when CH/HW is switched on the boiler wont ignite. the air switch seems to work when tested but im at a loss now. Could it be lack of...

Hi all, just a quick one. Can you buy a universal flow switch as the one for mine is quite expensive? If not I'll just have to shell out on the correct one. Many thanks, Jim.

Yes I think I would. Would this be a sphere type as the one that's on looks like a steering wheel disc lock.

When looking at the boiler the valve is at the top rear right of the boiler.

PRV is OK and dry, The expansion vessel is at the top and to the rear. looking at the manual its a big round thing with a valve on it.

Hi all, i have a Ferroli 77ff combi, over the last few months it has been loosing pressure on a regular basis. i have done some research and the expansion vessel was suggested. when i went to check the pressure a fair bit of water came out of the valve and there was hardly any pressure. I'm...

Not really, people come on here to get advice from so called professionals :oops:, not to read tit for tat comments of two strutting stags. Just stating what everyone else who has read this is thinking. End of opinion.

With all the BULLSH*IT, have you actually given jonathanhall any advice that he came on here for? PM each other next time girls instead of destroying a thread just to prove who is right.