Search results

I tried base spindle today again to double check and it moves freely when turning on but to move it from on to off it is very stiff, give it oil but will need replaced as is still little stiff and not moving freely. Can I replace the base on its own and if yes do I need plumber or is it a DIY job?

Yeah got inside and motor was tight

Yeah can turn the brass base spindle by hand no problem. It a pain tho as to turn heat off have to remove motorised valve and then turn spindle by hand to shut the heat/boiler off as when turned off at programmer the valve doesn't shut the heating off. Turns on OK just not off. Would it be a new...

Hello Central heating not turning off when switched off at programmer. Gas ideal logic 24 boiler. Motorised valve Ds222p. It comes on OK when switched on just won't turn off again, when I detach the motorised valve I hear it turning then to go off when it has been detached. I have to manually...

Ideal logic heat 24, installed 2013 and serviced last week no issues Having touched temp of boiler always kept at economy mode but don't know if relevant but had boiler fault middle of December which resulted in CH motorised valve replacement (with cable ties) then new pump replacement start of...

Checked for 15 mins and no water opening into tank whilst CH only running. Is it time to get tank replaced or anything else u think needs checked also, cheers

No discolouration in hot water When turned on HW and water started to flow top circled pipe went cool(was still hot before HW turned on) and bottom one warm but top one was first to heat up properly were u could just touch it. No sign of overflow will double check tomorrow Yes smaller loft...

Yes that's correct both circled areas hot and pipework from valve until it bends coming down not hot. Heating off now 1hr30mins and circled area above the stat is still hot all other pipes cold and immersion still off at circuit.

Have turned the immersion off at circuit.

The two pipes that connect to coil are hot same temperature. The pipe from HW motorised valve is only hot in the circle part above the stat.

Pipe below HW motorised valve has change in temperature when HW turned on at programmer and shuts off when turned off. Any ideas what needs looked at next why water so hot in hot water tank when not turned on? I also got a new pump installed last month. Cheers

If I swap them will I still not have a problem with the HW valve body that needs replaced per previous answers?

Sorry forgot pics

I currently have Sunvic eml 3454 body, should I replace with same or Danfoss hpv22 valve body to match Danfoss actuator? See picture looking to see what pipe under motorised valve is for? CH valve was recently replaced under insurance and have just realised its not secured on body with screws...

Does the whole system need drained down to replace?

Turned on CH, pipe from HW motorised valve is slight warm can wrap hand around it and hold on, very hot pipe leading to HW valve and can only touch that. Is this an easy fix and we're do I start?

How do I check if valve open? Yes hot water tank stat, tried 60,50 and then lowest but didn't change anything. Yes immersion is off

My hot water is too hot for washing hands. I have water off on my program and its still getting hot maybe when heating is on. I have replaced the cylinder stat and replaced actuator danfoss hpa2. When replacing head the valve on body was moving freely. The pipe from motorised valve to hot water...