Search results

I have water hammer, turning off my stop tap doesn't stop it. But turning off my external one does. This suggests the problem is with the external stop tap?

I need to replace the fill valve on this, I was going to do the flush valve too. Can anyone recommend a good flush valve that will fit. The one that's in looks like a 2inch outlet. Thanks

Can I ask which is the best of these on the market please?

As anyone swapped an on/off Cartridge on a concealed shower and then when turning the knob full off it goes past the vertical position. On the picture the valve is off I.e no water coming out of the shower. But the top knob will move another 5-10 degrees to fully off/stop position. I can't take...

Does this look like it could do with regrouting abit before I re-seal?

I have a shower area to re silicone the silicone were the tray meets the tiles is nearly none existant. But the silicone that is applied in the corners where the tiles meet going down to the tray is perfect. Do I need to remove this silicone that is applied to the corner were the tiles meet and...

Went to a tank were I need to swap the fill valve the over flow is higher then the full valve. I was going to put a part 2 on it but still won't have an air gap. Any one come across one poorly installed before. Thanks

At what level would you set the water line on a F&E tank. So it doesn't expand above the overflow level. Thanks

I have a pair of rothenberg 15/22mm pipe benders. There is a few dots on the former. Am trying to figure out what to align with what to do a 90 degree bend. I had the old hilmor ones before. This had a line on the former were to pull the bend with to get a 90. Thanks

When bending a partial pass over just big enough to get over a 15mm pipe. To what angle should you pull the first bend?

Should this bar shower swap ok. Have a new one with the same centres. It's just there isn't many threads sticking out beyond the shrouds to make a seal. Thanks

Can these be fit externally? Also does A1 rated mean it can be fit below the flood level of the basin?

Can you take a the cartridge apart on a dripping ceramic disc valve. Grease the ceramic discs with silicone grease to stop them dripping? Saw a video on it. Thanks.

I have some ceramic disc quarter turn bath taps were the grub screw is between sizes. 2.5mm too slack. 3mm too tight. Is there a way around this so I can tighten the grub screw.

I have a mono block mixer with a single lever i believe this sits on a plastic stud below. I am removed the allen key and the lever is still tight to remove. Is there any tips? Its metal on plastic so wouldn't think would seize. Thanks

How much would a plumber possibly charge labour to move a radiator from one size of the room to another. And swap another radiator like for like. With new valves. Combi boiler system. Thanks

Can you swap the flexis that come with monoblock kitchen taps for the copper tap tails? I want to try get better flow. Thanks

Can the pressure relief from these 15 litre unvented cylinders go into a waste branch that has over appliances on it?

Would a Flexi installed like this before ok. Would be for a concealed cistern. Or would that be classed as going up hill?

I have this concealed cistern 500mm it's tight too tight for a soldered bent tap connector are end feed ones tighter? Or any other ideas? Thanks