Search results

I have a texecom premier 48 alarm that I have added an additional keypad to so I can alarm my garage as a separate area. I have used the two zones to connect a door switch and a PIR, and enabled these zones in Wintex as zones 10 and 11 (and then tried again with them set to 41 and 42)...

I have a garage that is partially built with celcon blocks. IS rendering the only way to waterproofing them? One exposed wall should be easy to render (except the lower half of the wall is painted) but for other the only access is from the roof (but only the top half of the wall is...

I have a 3metre concrete lintel (100mm wide). It has a rough side and a smooth side - which way up should it go? And what would happen if it went the other way up :? Cheers Paul

I am replacing the roof on my garage, as the current construction is inadequate. The current joists are 38x220 at 600mm centres for a 6m span. I need 75x220 joists at 400mm centres. Therefore I'd like to reuse the 10 joists I have by bolting them together to give 5 of the correct size...

I want to fit an alarm to my house and detached garage. I'd like to be able to disarm the house without disarming the garage - can anyone recommend me a panel that can do this? I don't really want to have to disarm the whole system and then part set the garage - as this will occasionally...

I have externally opening UPVC french doors on both my garage and back doors. Neither of them are overlooked, so I would like to increase the security on them as I believe the exposed hinges are a weak point. Is there anywhere where I can buy hinge bolts for UPVC french doors? I have had a...

I am about to run a new armoured power cable underground to my garage and at the same time I want to run an extra cable so when I fit an alarm I can add the garage in as an extra zone. I believe if I just use standard cable it will break down if it is buried, so is there any cable available...

I removed a radiator several weeks ago, and I now wish to fit a towel rail with TRVs, however I don't know which pipe is the feed and which is the return. Is there an easy way to work out which is the feed and which is the return? The system is currently drained down.