Search results

6 X 3 GATE I want to hang from the left, what size t hinges, 18? screw sizes about 1/12? leave 10 mill either side of gate for clearance? any tips for hanging, and fitting a latch to open from both sides t hinges, do they go slightly over for the clearance? any best...

Whats the best method, cut top and bottom nr window, fold the leftover around, and do a peice to fit in I seem to get a slight gap cheers Weres the best place to do a top cut, could do to see a video, make it easy to understand

Boxing in pipes with plaster board, I tried to use dot n dab adhesive to box in it was on a papered wall, I take it, it dont stick to lining paper or any wallpaper?

I have seen hot bitumen spot bonded, and some dont use the felt with holes in should you always use the felt with holes in, so the deck can move or is spot bonded done so the deck can move

Do you pva before dot n dan on bare brick? Best thing to stick plasterboard to a steel lintel, the underneth? Brick opening is a bit rough, could i fill gaps with morter, then dot n dab, or use something else, some gaps about 2 inch diff in the brickwork, that was cut out exterel...

Some walls have been repaired with morter, can i just paper over?

simple garden wall I measure the lengh, dry lay, if it ends needing half a brick, how best to do that, or maybe make sure it ends take a full brick

5 ft above ground, panels attached, could only dig to about 18 inch, too much concrte below that, all concreted in there is a slight movement on the post if try to see how hard it set, its only been done a few days would you say it should be ok, i mean movement of a about 2 mill

On the flat roofs, do the green mineral drips follow a correct way to go around the roof?

Would just going over ridge tiles after removing loose pointing, and then pva last? some ridge tiles are solid, just a bit of loose pointing