Search results

Meant to update this last week but the problem was the PCB. ATAG sent a replacement pre-10am and with a little pushing I had an engineer to install it within 24 hours thanks to Wayne Herbert at ATAG. I was a little concerned when deciding to choose this make about the spares situation but this...

Hi and thanks for any responses to this. I have an ATAG E32C which has just started to produce an error code E0:29 and the fan is going at full tilt when this happens. It seems to be that the DHW is getting too hot and kicking out the boiler but I may just be misinterpreting the display -...

Mmmmm I sent you one too ... but there is nothing now showing in my outbox .... v v odd! :) Did you get it?

Hi Superdupergasman That's why I am confused - the overheat ISN'T tripping at all - and the boiler can be relit without touching the overheat .... Thanks for your input tho.

WDIK Now I AM confused! Was your comment about something being bog standard on commercial boilers and gold plated contacts really in response to my thread about an over-heating Worcester combi that you contributed to yesterday - if so I am way out of my depth .... :)

Hello WDIK I think your last was destined for another thread ..... Regards

Hello Tony Thanks for your response. No, there is no mention of a pump overrun stat - it has a flow stat but i guess that is not the same thing .... ?? Yes, I can send you a scan of the circuitry - what mail address do I use? Thanks

WKID Your comment about this not being an out dated boiler is the first time anyone has said that - it is the first thing everyone else I have spoken to says first - but I would guess that is because you have been in the buisness long enough to have experience of these older systems. It is...

Hello WDIK Mmmmm - I would like to think so but due to the age of the boiler there are few heating engineers around that have worked on this model and so there seems to be a shortage of knowledge on what might be the problem .... What else might it be? Oddly, as I have the original manual...

Hi Wilder74 If what you are suggesting is the case wouldn't the overheat stat be tripping out? If not what else would be causing the pilot to be extinguished which I assume is happening because the gas valve is closing .... Thanks for your input.

Dave I only say that because the new overheat isn't tripping out either before when the pilot goes out after a few hours of running the rads or after turning off the hot water and it doesn't need to be reset before relighting the pilot - basically it is not reacting as though the boiler is...

I just found this forum and hope someone may be able to help so thanks for any replies The boiler is a Worcester Senior 6 B/F Combi that has had both a new overheat thermostat and thermocouple fitted recently. After a few hours of running 7 radiators apparently normally it just shuts down...