Search results

Would the above do it without load?? The immersion wasn’t being used and also isolated by a circuit breaker inside the appliance??

Thanks for all your input guys, the fault turned out to be the lmmersion/element, even though it wasn’t being used, suspected earth leakage going through the neutral, during fault finding if he disconnected the earth on the immersion the fault still happened but when he disconnected the neutral...

Sorry that’s the only photo I have from a few weeks ago, I’ll upload a photo tomorrow when I’m at the job, ghanks

It could be any combination of appliances and the Boilermate

The Boilermate has been put on its own rcd, Boilermate runs 24/7 no problems, but if you use kitchen appliances and the Boilermate the Boilermate rcd trips, thanks Edit, the red switch for the Boilermate trips, electrician refers to them as rcd, 2 different sparks have been to job but still no...

Hi looking for advice on a tripping rcd, the customer has already had a new cu fitted, the problem is a Boilermate, works ok on its own 24/7, kitchen appliances work, microwave, dishwasher, oven etc with no problems but as soon as kitchen appliances and Boilermate run at the same time the rcd...

Hi looking for advice on a tripping rcd, the customer has already had a new cu fitted, the problem is a Boilermate, works ok on its own 24/7, kitchen appliances work, microwave, dishwasher, oven etc with no problems but as soon as kitchen appliances and Boilermate run at the same time the rcd...

Will do, need to be tomorrow though, thanks

Hi, when I switch it on it lights brightly and fully then after 5 mins it goes completely out, no glowing or flickering

Anyone know about the light attached? It’s been lying in the loft for years and I decided to fit it in the shed today, the light will stay on for about 5 mins then go out, by the model numbers can you say if it’s a sensor light and should be acting as above or should it stay on when powered? Thanks

I’ve had this before and a non return valve fitted on the cold inlet pipe work to the Combi sorted it, the boiler would fire when the toilet was flushed

Try holding the menu button and the return button at the same time, do this for ten seconds and factory reset should appear. Ps remember you have a grey button on the receiver which will override the command and get you’re heating up and running.

Is the hot water programmed? If it is put it to 24hr/all day

If it's working with the link in I'd suspect the receiver is not switching between 1 & 3 Too slow again, lol

A symbol with both a radiator and tap sign? Try your connections at the boiler are good and if you have a multimeter check for 240v between the two wires, when you've put a demand on for ch Sorry typing to slow:~(

Winter mode is for ch, turn selector switch to winter and make sure timer is on constant

When you press the override button on the receiver and the green light comes on for ch demand do you here it making a click (switch making)

Have you got the selector switched to winter mode??

Have you got a boiler contract with British gas? If so you'll get hive for £99 as you've faulty controls If not tool station and b&q do it for £180

No nothing dangerous and your water should heat aswell, any local engineer will have it fixed in no time