Search results

Yes. Basically the hot water on runs power to the boiler. The boiler gets hot and water gravitates to the cylinder. No wizardry Heating on runs the pump via the room stat. If you had the correct programmer then whenever you put the heating on, the hot water output is automatically triggered as...

the hot supply is being compromised with higher pressure cold water from another valve / tap. You need to figure out from where.

Usually a little switch on the back or a link to move. The heating relay needs to activate the hot water relay for gravity hot water. It seems to not be a feature on this particular model. You either need to exchange it or you could install an external relay to turn the boiler on with the...

Because the pitch is so low the rain will just run in through the slit in the felt above the flue.

Water is getting under the tiles further up and running down the felt which is obviously its purpose but rain will easily blow in through the sides as well as the tiles are pretty pizz poor. The lead slate is fine.

Scenario is vertical boiler flue through a very shallow roof with pan tiles. The roof has breathable felt. Inevitably rain found its way onto the felt and through the split in the felt, ran down the flue pipe and into the boiler. The boiler has just been replaced and the roof needs sealing...

Basically wired as per image. However i have rcbo. I think because only one side of rcbo is wired its causing it to trip. Thoughts ?

Does anyone have experience with emporia energy monitors?

I hadn’t spotted it was AC on the outlet side of the psu ! Ok will just wire supply to keypad from that. Thanks everyone. Will post up finished job

Thanks, could you possibly give me more detail on this ? Separately i was presuming 150ma was the maximum load the relay contacts would take.

So i have got a RGL KP50. Ive wired a temporary power supply using an old 12c plug i found im a draw and got it programmed at home. It has multiple relay options but just using the lock 1 set to temporarily short the sbs gate control terminals which the existing set up uses. So enter code to...

Thanks. the controller is 24v though looking at the image or is that just to drive the gates? Yes. Just want to open and close the gate separately as it currently does. The current wiring configuration does this on the sbs set of terminals being used. I think i just need to put another pair of...

Thanks. Currently the gate does not auto close and needs to stay the same.

Thanks for your input. The most important thing is being able to share an access code with people to gain entry from outside.

This is the setup. Can you please advise a suitable keypad

Thanks for your replies. I will go tomorrow and take lid off the adaptable box to get some info.

Do i need to check then if its running 12 or 24 volts

Hi. I need to urgently add a key pad to my elderly parents gates. They currently open them with key fobs or a button inside their property. However we now need to open them independently from outside with a security key pad. Can anyone please advise on this. I understand it will be wired in to...

I wasn’t aware Aqualisa made an electric shower

Anyone able to id this shower please