Search results

  1. B

    Thermostatic Shower too hot and no cold

    Hi Having problems with a thermostatic shower (Triton Altair I think) Although unconventional, we had to plumb in using cold mains (with PRV) and hot water from cylinder (which sits at floor level). The unit works on low pressure systems (0.1 bar min) and although it was not the most...
  2. B

    Mains fed Thermostatic Shower Unit??

    Hi, We have a thermostatic shower mixer connected to cold mains and hot water from cylinder. Flow is pretty poor but it is warm enough. Would attaching a pressure reducing valve to mains feed to shower help? Have replaced hot service with full bore, but no joy... Tank in loft feeds only...
  3. B

    Combining basin & shower waste to exit into existing hop

    Hi, Just created a new ensuite next to existing bathroom. But because of sloping roof, basin and shower enclosure have to sit opposite outside wall. My only option is to use a reducer 32/40 (basin to shower), then combine waste pipes underneath the shower tray and then run this outside into...
  4. Grey line showing waste direction?

    Grey line showing waste direction?

  5. Untitled

    Untitled

  6. Plumbing probs

    Plumbing probs

    Plumbing
  7. B

    Laying copper pipes for gas & water under screed.

    Thanks for all the useful info!! I think we'll get a few more corgi men in before deciding what to do with the pipe extension...! I'm guessing they'll favour extending it through the ceiling void, but it would mean a few more elbows, how many are allowed? :?: Bit of a pain as ceiling...
  8. B

    Laying copper pipes for gas & water under screed.

    Thank you! So, if I have this right... I can run speedfit pipe in speedfit conduits (presumably taped at conduit ends) for hot, cold, flow & return. For gas, I'd need a separate duct with ply lid that is flush with screed around it and not tile over until corgi man comes? Run is just...
  9. B

    Laying copper pipes for gas & water under screed.

    Thanks for the reply! Sorry for my confusion, but what do you mean by ducting? What is the difference between ducting and conduiting? :?: :oops: If we replaced all but gas with plastic, can I just use speedfit conduiting and then tape over at conduit ends? :?: My local plumbers...
  10. B

    Laying copper pipes for gas & water under screed.

    Help!! Our builders have laid 5 22mm pipes under screed in kitchen (for flow, return, gas, hot & cold). All were wrapped in 1 layer of denso tape, although one pipe lost part of the denso tape when they had to dig up near the pipes! :roll: These pipes are to feed directly into a new...
Back
Top