Search results

Hi Having problems with a thermostatic shower (Triton Altair I think) Although unconventional, we had to plumb in using cold mains (with PRV) and hot water from cylinder (which sits at floor level). The unit works on low pressure systems (0.1 bar min) and although it was not the most...

Hi, We have a thermostatic shower mixer connected to cold mains and hot water from cylinder. Flow is pretty poor but it is warm enough. Would attaching a pressure reducing valve to mains feed to shower help? Have replaced hot service with full bore, but no joy... Tank in loft feeds only...

Hi, Just created a new ensuite next to existing bathroom. But because of sloping roof, basin and shower enclosure have to sit opposite outside wall. My only option is to use a reducer 32/40 (basin to shower), then combine waste pipes underneath the shower tray and then run this outside into...

Help!! Our builders have laid 5 22mm pipes under screed in kitchen (for flow, return, gas, hot & cold). All were wrapped in 1 layer of denso tape, although one pipe lost part of the denso tape when they had to dig up near the pipes! :roll: These pipes are to feed directly into a new...