Search results

Thanks for the reply. :D

I have a situation where i would like to install wet under floor heating in a smallish entrance hall. size of the room is 3 mtrs x 2.2 mtrs wide.The floor is concrete. I would like to lay some old york stone paving slabs i have some of which are 2 inch thick on top of the under floor...

cheers again Woody. You will be glad to here i have order my materials today. I have managed to source a Knuaf board with vapour check included. So Gables will be insulated as follows: batons, fill air gap with rockwool. then 40mm board with vapour check. other walls: as above...

thanks again woody. i really appreciate your time to ans my questions. i will use some of your suggestions on the walls where i can't afford much space as they sound the perfect solution. when i asked in my previous post about the benefits of batons, i was wonder if using batons and...

thankyou for your reply woody. I am going to go with the 30 or 40mm Gyproc boards You say these can be bonded straight to the wall. If i baton and then board what are the extra benifits. I can afford ( space wise) to baton some walls gable end etc. If i baton the wall. Can the baton...

sorry i meant thermaline basic by gyproc 30mm

thank you for your input i would be struggling with the 62mm boards plus the 25 . i take it i would be able to use a thinner board and just not have as much thermal protection.? could i use therma board instead of kingspan?

Can anybody help with my situation? I want to insulate my solid walls, i think i have read to many articles on this and have left myself confused and frustrated. After reading about the different ways of insulating the walls, i have decided to use thermalite basic board @ 40mm thick which...

Hi John thanks for your reply. I am going to insulate the walls after what you have said. Please could you explain what it is i need to do,i don't really want to go much thicker than 20-25mm or it will mean i have to do something with the window sills as the plaster board will come out...

I am on with renovating a old farm house. When i moved into the property the heating was run of a solid fuel boiler, i could never get the place warm, i calculated that there were insuffcient rads in the house, 21K btu and it needed 65K btu. I have just installed a trianco solid fuel...

Hello. Could anyone give me any advise on boosting my water pressure. My water is supplied via a spring and feeds 2 properties. Currently i have the following installed: ( in a kitchen cuboard ) 1 Pressure system ( it looks like a compressor ) with a blue tank underneath a motor...