Search results

has anyone fitted one of these yet? are they any good or just something else to give us a headache in time to come? been asked to fit one but would like some feed back before I commit myself tia

the 75mm trap seal is to counter act the effect of self or induced trap seal loss. but with a shower or bath there is residual water droplets that slowly work their way down the plug hole refilling the trap if the sael was to be lost...

flow switch... you can trick it into giving warm water by running CH while running tap. the 2 mins off is the anti cycling programme

no its a power shower, only suitable for stored hot water systems.

the 10 programme position is normally used when the hot water is on a gravity system. In this case it is not possible to have CH without HW The 16 programme position is normally used on a fully pumped system using 2 or 3 port valves, thus allowing independent control of HW and CH. if...

look at this http://www.screwfix.com/app/sfd/cat/lrgimg_popup.jsp;jsessionid=FJHTYIU2D2YRYCSTHZOCFGA?productId=51167&imageNo=null&ts=10520

so its leaking from the PRD (pressure relief device) if you replace it then it should stop leaking

the 1/3 is to determin the height of the open vent pipe minimum =150mm + 40mm ( for every metre of system height)

its indicating a fault either with the overheat stat, or with the boiler. possible causes:- faulty sensor, worn pump, restricted water ways. you should get a Gas Safe Registered engineer to look at it.....

have you googled the cylinder to find installation manual? if its an unvented cylinder the expansion bubble or expansion vestle has lost its charge, the manual would give you the details to recharge this.

does anyone recognise this sand filter fitted to a spring fed water supplie who can shed light on a trading name or product name for it?

part center still have a standard flue listed for 4131139 and 4131140 which is the BF & RSF models but if yours is the 4131138 OF model then there are none available.

25 gallon / 117ltr would do it. head would need to be 300mm above highest pipework or cylinder for it to work

if the second butterfly flap is fouling can't you give it a light sanding? about a 20min run after shower should reduce condensation.

what size cylinder? what type of building?

http://www.gainsboroughshowers.co.uk/parts-store/Gainsborough-Showers/Gainsborough-85SE/3216/ You would need to consult an electrician about an electric shower upgrade. http://www.tritonshowers.co.uk/ click on help me choose. to go for a power shower will mean pipework changes.