Search results

i have a cast iron stack i need to cut into for an additional downstair wc,, the problem is the space is zero,, well tight, it is a very busy corner of the house,, cold mains, electrics, the usual carry on the only way i think is to get the reciprocator out but i have never used it on cast and...

i have not heard a good word about these boilers but anyway this is 4 years old and making an awful racket,, it does it when it fires up, it's as if it's banging off the wall ,, like theres too much gas in there before it lights,,

went to a worcester 28i,the red light was off,checked main board had'nt tripped+fuse at spur,both were fine but we got the light back on by changing the 2amp glass fuses but still nothing worked . fault finding book pointed to the pcb which got changed + still nothing, any ideas :(

need to change pressure vessel but unsure if it's a 10litre or a 12litre or what difference it made if any, i know it's 300mm in diameter, went to re-charge it and the water was flying out where the air should go in,

alpha he cb 33 , in order to get hot water the central heating has to be on is this the diverter valve? is this a common fault? do you recommend a new syncron or full thing that is if it is a syncron motor can't remember

i am tying to set up a drain test for a building control officer coming this week for final inspection and as usual the house is completely finished . I cannot for the life of me get the test to hold, the underground has all passed, it is like an open end. The problem i have is that the builder...

i have a 54 plate piccaso which i bought from a citroen dealership and it came with a years warranty, about a month before the warranty expired the fuel pump packed in and they replaced it in february. i normally put 20 or 30 bucks of diesel in at a time until today when i filled it only to see...

we have a kitchen appliance under warranty but when the repair man came he got a small electric shock off it. he then plugged a testing tool into the kitchen sockets and said none of them were earthed. how can this be and is it a difficult job?

indesit evolution 1200 we12 making mega noise. i'm guessing it's bearings are gubbed firstly is it a job a plumber could manage himself and also how much roughly are the bearings if it is them? thanks

could any of you expert sparks advise a novice on how to use a multimeter please. i am a corgi registered plumber who mainly concentrates on installs, ie i would normally get a service engineer out to a combi breakdown if it was'nt blatantly obvious to me what the fault was. also i have been...

what do we think of sabre boilers? a guy wants me to fit one for him as he is selling up the price of it is certainly eye catching although the alarm bells usually start ringing just wondered if they were tom kite

electric shower , any common faults to these? 3 years old at most. i would normally just replace it but i'm skint, any ideas? i have a trevi in my store that i was going to flog to my next bathroom customer, if all else fails :cry:

called out to a baxi 401 back boiler/fire front yesterday. new gas valve required. lady then asks to have boiler and fire serviced while i had it all stripped down which i did when i told her how much it was she said i was ripping her off which of course i did not. please could...

brand new biassi boiler (condensing combi) 30kw, poor hw temp at max on stat, inlet gas pressure spot on