Search results

Hi, My built-in oven is permanently on (I have to switch it off at the circuit-breaker) and it seems one of the relays is heat-damaged and the contacts are welded closed. (See image). The control-board is part number 4619 615 12252 which I can no longer find. I have decided to replace the (very...

Hi, According to many online resources, my Whirlpool AWO 12763/1 takes the following brushes: 481236248004 https://www.servis-whirlpool.cz/nahradni-dily-pracky/uhliky-motoru/uhliky-motoru---par-13-6x5x32-mm--leve-481236248004-481236248004 (Yes, I live in the Czech Republic, and no, I cannot...

Thanks both. Replaced with a Grundfos Conlift 1 from Screwfix. SO MUCH QUIETER! M.

Hi, My Saniflo condensate pump (NS01-CD10) sometimes seems to get a bit stuck: it whirrs and goes very slowly before finally speeding up and pumping out the liquid. I have disassembled/reassembled it and while on the living room floor it works. The outlet tube is not blocked and the water...

I have disassembled the room thermostat/controller cleaned the contacts with fine wire wool and replaced the batteries with new ones. I have tried things like swapping the left and right battery trays. However, the only way I can get the connection back is if I power down the BOILER (thus...

So I have been told I am getting a smart gas meter from Npower - is this a 6m3/hour maximum flow rate meter? Thanks M.

My house is has 32 linear metres of soffits and no gables (the roof is a square-based pyramid, sloping on all four sides). The house is detached. How much should I expect to pay for fascia, soffits and guttering? Should I get these done before getting the house re-rendered and getting the...

Yes, it is frost free.

Room temperature is around 19 or 20 celsius.

You're probably right - if it's a simple part replacement though, I'd rather do that.

My 15 year old Blomberg fridge freezer has stopped working. The fridge is fine, but the freezer is at room temperature. Is this a problem with an obvious and easy fix? Thanks

I realise that one can use a current clamp meter to measure current in a single conductor, but is there anyway to measure current in twin plus earth without disconnecting it or cutting it? Thanks M.

Thanks ban-all-sheds. I guess this means I would be better off replacing my old fuse board with a new consumer unit with RCDs?

No

What kind of conduit is necessary for running mains lighting cable in plaster vertically upwards from a light switch to a point above the ground floor ceiling? There will be three cables from a three gang switch for three separate lights in the room. Can someone please provide me with a...

After cleaning I can see that it is made of light coloured plastic: It was wound round the shaft where the red dot is on this image: Perhaps it fell from somewhere else and got caught there! Here's a view of the rear of the washing machine for reference:

This fell out of the rear of my 15 year old Hotpoint Aquarius WM23. Is it part of the bearing? What do I need to order to replace the bearing? Thanks